• Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!

  • Microsoft MSN, Live, Hotmail, Outlook email users may not be receiving emails. We are working to resolve this issue. Please add support@steelsoldiers.com to your trusted contacts.

BeStihl's latest activity

  • BeStihl
    BeStihl reacted to Tinstar's post in the thread MEP-803A —— Did I Score? Maybe….. with Like Like.
    So it’s home Lots of spiders and fuse mod has not been done. Nothing looks chewed and no sign of anything except spiders. I do see...
  • BeStihl
    BeStihl replied to the thread New to me MEP-803a.
    10-4, I appreciate the insight and I will do as advised. I was just making sure I wasn’t “leaving anything on the table” so to speak, if...
  • BeStihl
    BeStihl reacted to LuckeyD's post in the thread New to me MEP-803a with Like Like.
    Unburnt fuel residue. Higher loads may burn this tar looking stuff off with time as it cleans itself out on your loads. You may even...
  • BeStihl
    BeStihl reacted to 98G's post in the thread Need Help with my 802A …. with Like Like.
    Facing the control panel, it's a switch toward the right hand side down low. It s referenced in the start up procedure. Lift up on it...
  • BeStihl
    BeStihl reacted to kloppk's post in the thread Need Help with my 802A …. with Like Like.
    To me it looks like an issue with the connection of the braided fuel return line. It's all frayed.
  • BeStihl
    BeStihl reacted to LuckeyD's post in the thread Mep-802a temp gauge reading. with Like Like.
    Seems two folks using the same stuff with same results kinda sorta resolves the issue. Nominal readings in the desert at 115F outside...
  • BeStihl
    BeStihl reacted to LuckeyD's post in the thread 803A Hits a Wall at 9.3kW with Like Like.
    OK, you got 9000 watts. Run it with that or about 8500 Watts and after a while it may even provide more as the rings seat again and...
  • BeStihl
    BeStihl reacted to LuckeyD's post in the thread 803A Hits a Wall at 9.3kW with Like Like.
    An extra gage you can verify your panel gage. The panel gage may be incorrect. The LOP is set for just under 20PSI. Hope so ruling...
  • BeStihl
    BeStihl replied to the thread New to me MEP-803a.
    Thanks for the time and detail of your response. Just to clarify I am using the house GRod with 6ga/4 from Genny to transfer switch, the...
    • IMG_2547.jpeg
  • BeStihl
    BeStihl reacted to LuckeyD's post in the thread New to me MEP-803a with Like Like.
    In words of my mentor; "GOOD DEAL". I use the same amp probe. You indicate 50 AMPS set at 120/240VAC out. The attached is a pic out...
  • BeStihl
    BeStihl reacted to vrzff's post in the thread 803A Hits a Wall at 9.3kW with Like Like.
    My overlord will not allow me to run the generator on a Sunday night, so I'll get on it tomorrow afternoon!
  • BeStihl
    BeStihl reacted to handyjay03's post in the thread 803A Hits a Wall at 9.3kW with Like Like.
    I was finally able to look at it again this afternoon. Set my frequency to 60HZ with the 4590W load on it, and it stays around 61.5Hz...
  • BeStihl
    BeStihl replied to the thread New to me MEP-803a.
    Ok I have managed to put over 100 hours on this unit after fluid and filter changes. I have been happy with the results so far but am...
    • IMG_2575.png
  • BeStihl
    BeStihl reacted to kloppk's post in the thread Mep 803a No/Low Low Power Output with Like Like.
    Don't cut any wires yet. You need to do some more measurements to isolate where the problem really is. Based on your reported...
  • BeStihl
    BeStihl reacted to Guyfang's post in the thread Mep 803a No/Low Low Power Output with Like Like.
    Iron Horse, Never guess or assume. TEST, TEST and RETEST. Kurt's got you on the right track.
Show older items
113,370members
166,655threads
2,346,703posts
1,258online users
Top
✖
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website like our supporting vendors. Their ads help keep Steel Soldiers going. Please consider disabling your ad blockers for the site. Thanks!

I've Disabled AdBlock
No Thanks