Recent content by birddog1106

I called Eastern would u believe they want $ 975.00 CRAZY I don`t use them much I know white owl/Jim Henry have them. I ordered ,my O rings from George at White Owl .I just ordered Six 15.5-80-20`s and just wanted a Spare. Getting ready for HURRICANE SEASON...

Yes,I agree not much strength in the sides also where can I find a wheel for a m35a3 ??.............TU

GREAT...........i`LL KEEP YOU N DA lOOP.................tu.....................vg

You do realize this is a dump not lifting the bed ??...................VG

Thanks for your reply.I will let you know how it works out---- I`m not doing the install.............VG

You don`t think it would dump 10,000 on a 12 x8 bed ??

Anyone used the above to make your bed dump ? Wondering how far forward from pins/hinge to place lift/cylinders........TU

Yes,Please Delete.................TU

Ray thanks for the reply.........I used a 10 lb Hammer nah just jokeing..Found the FS 1 fuse holder bad so I went to NAPA and got a 20 amp in line fuse holder and that guage on control panel went to 30 amps !! went I srarted it. I checked one battery (voltage) and I was at 14+ so Problem...

Yes Engine starts great/Powers up but battery voltage stays the same 12+ volts.

Thinking out loud Maybe running 40 Lube oil would give u just enough Pressure ??

Ray,Just got a 802 and it`s not charging the batterys.Had it ( alternator ) checked and was told working.Reinstalled and still not charging battery`s.Batt. guage on dash in Red ! Checked FS1 fuse it`s good Terminal in center of regulator showing 19+ volts any Idea`s................TU

Well we all have opinions and thank you for Yours..............VG

AS Before,I had NO Power at on/off (red) button. dash lights did not come on untill that 5 lb did it`s job. Also the fuel pump E-8131 works great and easy installation. No fault light.............vg

I got the power back with a LARGE HAMMER !! low fuel switch Hanging-up Installed new fuel pump 3181 I think was the number.Tks for your response VG