Recent content by Bokbfok

Quick update, I guess the tranny really likes fluid. When I initially filled it, it was in the hatch area. After all you comments, I decided to go look again, sure as sh!t it was low. I added a quart and still nothing, rechecked and still low, did this 3-4 times and finally got drive in R and...

Yup, right in the hatch area. I haven't drained any fluid so will not be able to tell you if there are shavings in the trans without dropping the pan. I am hoping it is something simple, but we will see.

Yeah, the case is engaged. I tried in H and HL. I don't get the trans light to light up in the run, bit not started condition. I am probably not getting power to the tranny, so I will start looking. My next steps are to check the breaked and relay

Did some quick looking today, appears I am missing the TCM capacitor. Could not find it in one of the TM's but found it elsewhere. I will see if the second M1123 has one and borrow it.

Oh, it came empty. Any fluid that is in there, I put in there.

Quick update, I ordered a new driveshaft that fits, thanks to Gayfang and the extra tid bit regarding the TM. I also got both batteries to life and was able to cranked the engine. I tried to find all the spots that they might have opened up for draining the fluids but once I got to starting the...

A Schumacher Electric SC1393 charger, some one on here mentioned or linked to a website that someone had success using it. Went through the desulfate process and then charging

The Armasafe 6TAGM, One was at 3 and the other around 10. Probably both goners but got them up to the 12.5 range over the weekend. They have been sitting for a few days and will check later again. Backup plan is to go get some 31's from Costco.

Thanks again for the tip on the UOC's, got a new prop shaft order and installed. Now continuing with all the fluids. The brake bleeder nipples are proving to be a PITA but will soak them in PB Blaster or something. The a batteries that came with were pretty dead and I will see if I can get any...

Ok, here is what the TM lists. For the M1123, UOC NNN, I need prop shaft 2520014132724 and I ordered 2520014590050. Explained! No. I see some vendors list those two shaft as the one and the same and other don't. I appears that there are a lot of liberties taken with these PN's? From what I...

:unsure: Ah! Thanks. I am still learning and had no idea what the UOC is/was! I just looked and I ordered the wrong shaft. Knowing about the UOC will definitely be helpful moving forward. Mullaney - Thanks for the info

Howdy all, As in my intro post, I bought a M1123 from govplanet. It is a roller and the price reflected that it definitely will need some work, which I am fine with. I generally find myself in the have more time than money category. Unfortunately, that sometimes leads to more spending, but I...

Thanks! Yeah, the timing just sucks right now. I will figure something out. I did however do something dumb and bought another. Boredom at works makes me do silly things like these. Hoping I can get both at the same time. Once I have them, I will gladly post more pictures!

Long shot here, but as in my intro post I just got my EUC approved. It came way quicker than anticipated. 20 days maybe? Anyone willing to quote transporting it from Yermo to Tucson? It is non running. Thanks!

Thanks for all the replies! I am planning on making the kiddo work on this, have him get some hands-on experience and away from the screens as much as possible. Or so I hope. I just got my EUC approved and can go collect. I just need to figure out if I want to have it delivered or go get it...