Recent content by C pope

Finally got to it and I only got .33 volts. That was at 1.5 turns out when I turned it in more I got less. Do you think the MPU is bad?

Yes it did run correctly. Have had it since 2016. Two weeks ago I was using it and it shut down. Went out to check and it had an over heat light. Started checking and found belt was loose. Got it back tight . Went to start it and nothing. Shot a little starting fluid at her and she...

Generator won’t start. It’s a fuel shut off problem. Tracked it down . The fuel shut off is not getting any voltage sent to it. I jumped power to it and generator cranks right up. Anyone know witch component controls the voltage to the fuel shut off?

The 804a genset that I have started out with a low voltage light. After tinkering and reading a lot on here i checked the fuse. It was bad so I changed the fuse. It is located next to the voltage reg(KLK-3). As I"m trying to starting it I get an over voltage light and it will not continue...

Cool, I’m hoping it will cure my problem.

Billy, Thanks that is better then what I found. I found just the voltage regulator. Did it fix your issue?

Guy, I think I have located the 804a voltage regulator. How many people on this site would you guess are currently looking for it? Part# 19870 NSN # 6110-01-368-7123 Got an email into them to see how many they have or can get. They like them an awful lot. The price tag is roughly 705.00...

Okay great! Where do you find a voltage regulator?

We checked it earlier and dad said it was good but will double check it in the am. Thank you for your time. Get your rest and happy vets day! And thank you for your service!

Needle drops to nothing

Yes

Light come on low voltage.

Cb3 did not need to be reset. When you release s1 the light goes out and the needle drops to nothing.

Cb3 did not need to be reset. When you release the s1 the light comes ( low voltage light). on and the needle drops to nothing.