Recent content by cafr11901

I spent a lot of time reviewing these threads after my set started overloading after 10 minutes at 50% output. Indeed, exercising the switches, cleaning terminals, and cleansing switches resulted in full recovery of my set. DeoxIT-D5 was used as recommended previously in this post and no...

So I can figure out how to measure it, but forgive my ignorance on adjusting the pressure the pump puts out. What would the process be for that?

After reading helm1008's post, I followed suit and installed my hinges with the bed still on and then used the tractor to lift the bed and install the hoist. Went to the pit and brought some sand home. Each time 5 tons was requested, but mileage may vary based on the loader operator. Three...

I installed mine from Kloppk last week as well, and it fixed all the problems.

The voltage on my M35A2 has started to run a little low this winter. I noticed that when I turn on the head lamps and run the heater (it's getting cold and dark around here) the voltage on the meter drops down into the yellow - almost toward the red on the meter. I hooked up a multi-meter and...

I just got my M35A2 a couple of months ago - and the first thing I had to replace was the batteries. I went with the 7235 batteries from NAPA in Marquette. My truck started up Saturday night. I wanted to see if it would or not given how cold it was. I took it to grab some ice cream for my...