Recent content by camdensc

Michael, Thank you. Both the old and new relay work fine..... I found that the small red wire connected to the small post has no power. I left the wire there, and ran a secondary wire to the post for power. It works great now. Thank you.

Can anyone advise the proper way to test a new gp relay while it is out of the vehicle? Would you use a jumper cable from positive battery post to top lug, then ground out one of the small posts? My gp control card went bad, and I tried to wire the bypass, and it still didn't work. I...

Thank you doghead

Thank you Mike.

Can anyone suggest a source for a replacement instrument cluster. I know that they are available on e-bay, but before I go that route, I would like to try and send some business to a member from this site, or a business affiliated with the site. Thank you in advance

I don't know how good of a deal this is, but there are 4 humvee wheels/tires on ebay with a buy it now price of $270, if anyone is looking for a set. The pictures look like the tires are in good shape. Hope this helps someone. I do not know how to link the listing, but the listing number is...

The right rear tread is almost bald compared to the other tires, probably from the tighter right hand turns at intersections I guess. Do you rotate your tires any more often because of this?

I appreciate it, thank you.

Will any of the oil additives help, or is it just the design of the Detroit?

When making slow speed tight turns, my 1008 has more inside tire "Skip" or "Spin" than I have been used to on my other vehicles. I believe that this is due to the type of rear differential. Is this something normal for our trucks? Thanks

Thanks guys. I may have been babying the transfer case a bit, not wanting to shift through neutral too fast, but it sounds like that is what may be causing my problem. Thank you again for the help, if moving through neutral faster doesn't help, and I have a hard time with the adjustment, I...

I am not sure about shutting off the engine either, but it was suggested by another member, and it worked for me. Turning the engine off did allow me to shift out of neutral, and up into 2WD, since the gears were no longer turning in the transfer case. Getting out of 4WD low isn't the problem...

I know I said I would check on things tomorrow, but I had to go out and make a test drive. This is what I found tonight. I drove a couple hundred yards in 2WD with hubs disengaged. Then I engaged the hubs and shifted into 4WD high- Everything good so far. I stopped and shifted back into 2WD-...

Thanks to everyone for the suggestions, I have been away from the house all day with my kids, and am just getting back in now. I hope to try out some/all of the advise tomorrow. Thank you again, I will let you know what I find.

I will try some of your suggestions in the morning, thank you.