Recent content by carey clarkson

Anytime Jerry. I owe you a big thanks for shipping the percent load current meter out so quick. Have fun in Alaska!:beer:

Carb rebuild kits are a thing of the past. Carb is very easy to take apart and clean. I purchase cork gasket material from automotive store and either trace the original or remove the float bowl turn upside down on the cork and start tracing. Then all you have to do is cut out and then trim the...

I know you stated that the injectors are known good ones however, even good Injectors leak down if something as small as a grain of sand gets in there. That would explain the build up of fuel and the black smoke during start. That said they could also be clogged with small to the point where...

I am in need of a Percent rated current meter for my MEP-002a however, most listings I see on the internet do not give an NSN number and don't want to order a part that will not work. They just give make/model/and dimensions. Most I have found are the correct deminsions and are A&M meters that...

:?OK guys I have a problem I haven't ran into before. I own 3 Mep-002's and have read the TM's at length to no avail. I can usually find the answer via a quick SS search however, this time I found everything but the fix to the problem. This Mep-002a is a 1989 model with a resent in 1992. Hour...

Where did you find the user manual for the LMT3000? Is it a user manual or TM? Thanks for the help in advance :beer:

4A032 carb rebuild The 4A032 carbs are very easy to fix if you take your time. I couldn't find the bowl gasket however if you go by your auto parts store you can buy a whole roll of fuel proof gasket material for about $5.00! Just turn carb bowl upside down on the gasket material and trace the...

Recovery 4X4, Coyotegray: Thanks for the info. I have been racking my brain for weeks trying to come up with a solution. :grd:

I tell you what, you can stop worrying about the fuel problem..I have the only solution.. I will pick them up tomorrow for $150.00 :-D. Congrats on the great find. How did you come up with a possible fuel pump problem? Did you check the fuel filters and I would disconnect the fuel line coming...

I have several MEP-016C Gen Sets however, I have not been able to find a defintative answer as to what position the Top Vent is supposed to be in during operation. The air vent I'm talking about is located on top of the Gen Set between the engine and the Generator, and it is spring loaded. When...