Recent content by Carolina1010

Anyone know what size and length for the bolts? Are there nutcerts down inside the hole?..........captive nut? First correct answer today I will send you a beer in the mail.......

Lol, I forgot the what I did part....... put a/c in the box. Stuck a small window unit where the factory blast chiller use to be, I'm currently modifying the case from original to shroud/protect/conceal the hillbilly of the window unit sticking out from the front wall..... This gives me a/c...

Well, this is my backdrop literally 6 days a week if I want it to be so.... I have roughly 10 hours a day to "hang out" and wait for my evening run to be ready and I found this gem about a month ago

I had a ford truck once...... It had a 2 piece driveshaft and the center support bearing squeaked, sometimes it sang like a bird...... Until it grenaded at 65 going down the road....... Lol, I pinched a hole in the seat and screamed like a girl when that thing gave up the ghost...

RP-342 heavy I'm no expert, but I've bought 40 year old rifle parts simply placed in a cardboard box with some cosmoline soaked paper loosely wrapped around it with no rust in water damaged boxes....... that wasn't the heavy mix but same stuff......it is thick and kinda waxy, and easily replaced...

Hi guys, Everything I have found on here has led me to believe I have a bad resistor on back of gauge or a bad sending unit..... But this morning my normally half full gauge when actually full, and seemingly correctly working anything under a half tank was reading full..... Not way over past...

YES!!.......LOL,that's the biggest difference so far, im looking forward to filling her up and getting a new base line for the mileage

Hi guys, I finally found a few free minutes and decided to try out the 4x4 Thing is, I have been unhappy with fuel mileage so far and when I found a good field road to play on I got out to lock the hubs and wouldn't ya know it, they were already in the locked position. I've read where this...

It was added after the fact, I think when the police dept had it...

I put in the iceco yesterday and discovered something weird....... The master battery shut off is not a master at all.......when on I have 24 volts to the rear power plugs (4 of them) But when the master is turned off I still have 12 volts to the plugs Outside of the obvious, is there anything I...

Yea, I saw the one on ebay..... I got a tube of the jbweld plastic epoxy repair w/gap filling abilities i think it was 6 bucks Its not the prettiest fix I've ever done but not too bad..... it'll last I think, though I did loose the ratcheting action, so I'm careful when I crank her down Oohhh...

Ouch! Ok, I just got motivated to break out the epoxy and/or super glue, lol I may still get it but for that kinda money I gotta try and fix mine first...... I will get the pieces parts together and take some pics

Hi guys, I'm in need of a new/used fuel cap, I looked around the forums but didn't find anything, can someone point me in the right direction? Thanks...

Here is a pic of the odometer, and also a pic of the voltmeter, it stays up in the orange but I dont think the batteries are needing that much charging, they seem fine and strong every time I fire her up, is that a normal thing for these gauges or do I need to start testing stuff for issues...

Hi all, Just wanted to brag a little bit about my ol" girls mileage and a couple questions.... 7,496 miles showing, I believe these to be accurate for a couple different reasons...... the zero to far left on odometer is in perfect alignment with rest of numbers, not offset like is typical when...