Recent content by Chanderson69

Thank you for the colored schematic. And yes I check for power at the plug. I know the pump works when I send power to it. I will work on it in the morning with the new diagram. Thank you all

After racking my brain on this TM. I can’t figure out what the wire number is that actually feeds into the main fuel pump. I see that post 3 is common but still unsure where it leads from there into the pump itself

I have not. I struggle trying to find the link for that

Hey, everyone. I recently purchased an MEP 803a with 320 hours. it’s in great shape and nothing seems out of place. However I’m not getting power to the main fuel pump through the master switch. Everything else works including the AUX pump. I can run a hot wire to the main pump and run the...

Has anyone ever felt with a generator with one of these toggle switch panels before? I recently bought three from an auction all with these panels. All of them having a short and not producing power. I believe number 3 and 8 control the fuel pump but can’t locate any other functions with the...

I will look into that. Thank you for the response. If I’m not getting the proper voltage what would be the issue? The regulator?

throttle is set in normal position and the Hertz gauge is reading 60. And the back panel switch is in the 240v single phase

I have an MEP 803a I recently bout with 500 hours. I am running a camper that has two A/C units on it and it’s only running half of the camper. The output needle will not exceed 25%. My multimeter shows 240v and the receptacle is showing 140v but for whatever reason it’s not increasing the...

Hello all. New to this group with some experience with military generators. I recently purchased an MEP 803a from gov planet. 2007 with tier 2 reset done in 2011 with 220 hours. The unit is only producing 50-60 volts on the L1 & L3 lugs. If I flash the field it produces the normal 220v 60 hz As...