Recent content by CHM

Thanks to all for the advice and information. After reading the forums and giving it some thought I believe that I will not get them and put the money into the truck somewhere else.

I do not know a whole lot about these as this is my first one. Why would they be of little use on the spray transfer case? Not arguing or anything just curious how the spray operate and why they would be of little use.

I m sure this has been posted before but I did a search and did not find anything. I have a 53 REO M35 that I was curious about putting manual locking hubs on. Does anybody have a link or part number and where to price or even start to where to look for them? I am not dead set on getting them...

Looking for a manual for my 53 REO m35. I have been told that there are certain ones that are on forum to look at but cannot seem to find the ones mentioned. I am looking for a wiring diagram so I can trace out my wiring to my lights and grounds.

Thanks. Is it up there in the TM section. It did say it in the dash data plates.

I looked in the manuals section and only saw stuff on the multi fuel and not really the REO 331. Looking to see what the oil capacity is on her so I can buy the oil and change it. Just bought the truck and got her home. Feels like a miss in one cylinder but going to give her a complete tune up...

I guess also if it is the sending unit are the sending units for the multi-fuel the same as for the gas fuel tank? I have found them for the multi-fuel but it does not specifically say they are for the gas as well.

I did a search and did not find anything but could have very easily not looked hard enough. The fuel gauge on my 53 does not work and I am not certain if it is the gauge or the sending unit. On these 24 volt trucks can you ground out the sending unit or gauge to see if it is the gauge or sending...

Neither of the windows would roll up in the truck and it is supposed to be fairly cold when I pick her up. I went down to work on her and one window was completely out and on the seat and the other one was stuck down inside the door. I noticed that one of the window regulators was missing but...

It has the wiring harness. I have not completely flipped it over to check the bottom but it look like a little surface rust in a couple spots but no other rust. Not certain what year it is off of but believe it is about a 53 like the truck is. Did they change very much over the years?

I have a garage she will be stored in with an interior height of 12 ft 8 in then another four feet or so to the top the roof. Not certain if that will be high enough or not. If not then not really.

Thanks. Could you possibly cut the shaft then weld a sleeve over it and then drill and bolt it as well to put it back k together if it is a problem?

The M35 I just bought has a pretty rough cab and windshield. It comes with an almost rust free cab and windshield for her. How much of a pain is it to actually remove the old one and put the new one in. I guess the biggest problem is lifting the old one off and putting the new one on. I also...

Memphis equipment has it listed as having them for $160 on their website but the carb kit link I received from cattlerepairman has them listed for $99. I have not checked into it much further than that as I do not have the truck home to get the tag numbers off of the carb.

I saw videos of her running and some of it being driven but was actually finally able to go and do a real good look and check out of her. Started up easily and really liked the way the REO sounded. The cab and windshield frame are really rusty but it comes with a good almost rust free spare of...