Recent content by coadydepeche101

Yes, the B pillar drops right in the b piller uprights already on the vehicle, just had to drill the holes through and add bolts. it is kind of spring loaded side to side but slides right in. i even added the seatbelt blocks to mount the seatbelt to and the rubber bumpers for your head to not...

I found the part # in the tm for a 1123 they are not really expensive but super hard to find in stock i got one off ebay one of some hmmvw part site If you do or did your c pillar be sure to but the set of c pillar braces they really tighten everything up and help get the right angle for...

do you know if there are any "add on " kits or do i just need to figure out what will fit? Thanks.. i figured you would reply since iv seen you have a lot of experience with these things

I had working AC on my M1114 but i hated the blocked view from the evaporator and the rattling of the condensor. I removed the rear unit and hoses, but is it possible to use only the front AC by itself? if so, what do i do? thanks.

wanted to update on the b pillar Rabbets, got the 3 piece original ones off, and got these installed. well worth the money. Still got to get the front hinges marked up and riv nutted, but happy with the outcome so far.

yea, i agree.. i know i say it does not fit.. but i really meant it didnt fit like i wanted it to. i could masssage the rubber and it would pop in.. and i thought about flap discing the edges so it would grab the sharp corners. i found the "Rabbet assembly" yesterday and ordered them. unlike...

BTW.. im trying to get just the trim piece that the hinge goes on and not the entire panel.. i know i can get those but thats out of my pay grade to get, and install. i may be better off just making one.. thanks

Hi guys, i did the same with the soft top, and i have done a lot of research on the lower part of the B pillar that is riveted to the outside, it is a little wider than the non armored lower part.. the soft doors dont fit (its really tight) so i removed it but i cant find the part number for the...

just in case anyone is looking for AC Vents "registers" for the front unit right side which is the bigger of the vents, the dorman part number 216-5403 from ebay is a perfect fit. 2" x 5"

thanks, i finally found it, (m1114 is actually 3lbs 4oz, ) i did vacuum it down. think i have a bad pressure switch.. Thanks again

i am trying to find the correct charge amount for an up armoured M1114 ac system. its the front and rear system. I currently have 3# 8oz in the system and the compressor has not came on yet. i cannot find the actual charge amount for these systems. i know they are bigger than the 1151 systems...

btw.. that ford in the pic is bas ass.

the turbos are not much different, they just whistle under throttle sound a lot quiter, at least from my experience with998, 1123 to 1114 turbo. no idea why the 1114 is quiter unless the inner armor they dont remove helps buffle sound. great trucks. good luck with your great build from Ga.