Recent content by Cowhunter

Thank you for the reply that was the way I was leaning i’ll make room and take the head off and go from thereI will let you know what I find or don’t find

Would not be any issue with this owner of a 005

Same machine different issue, it’s my MEPO05 a have used a few times for power outage also have kept it exercised fairly regularly with no issues the other day I decided to give it a good run I loaded it down heavy in about 30 minutes it was overheating I shut it down discovered I seem to have...

OK I’m back with an update I found hertz meter I bought it as a set of course the transducer was no good but I was fortunate enough that the other transducer that I had purchased worked with the meter just took a little tweaking on the balance screw to make it read proper also I purchased a new...

I I am going to attempt to post some pictures The first two are the new unit the second two is the unit I took out as you can see I was curious and I dug into the back of it the last two are of the existing meter I have

I got this transducer off of eBay it was brand new as in never been installed and it was a perfect match for the one I removed there was three adjustments screws on the back of mine.the one on eBay only had the two adjustments on the back of the transducer And appeared to have three screws to...

Well I had everything hooked up properly so at this point it appears that I am on the hunt for a new meter to go with the new transducer that I just purchased might be a little hard to find thank you for your help

OK I’m back I got my new transducer today installed it and still not getting a reading on the meter I do have 120 V going to it measuring the voltage out it’s 2.2 DC I don’t have any idea if that’s the correct amount and just another question I don’t think it matters which way you hook the 120v...

Yes I believe that’s my problem I took it off ,close examination the back of it doesn’t look right looks like it’s been hot I do have 120 V going to it while the GEN is running I could not measure anything coming out on the DC side. Thanks for your help I’ll post the results with a new one

Thank you for the come back I purchased this generator about 20 years ago I used it in my construction business of building homes strung power poles behind the homes and used a generator until the power company was able to Furnish power. After I retired it sit for about 10 or 12 years I decided...

Hello everyone I’m new to the site I have a Mep005a That has a couple of issues one being the batteries drain down unless I disconnect them I have traced it to I believe the alternator if I disconnect it then the drain seems to be gone But it does charge the batteries at a low rate while it is...