Recent content by customload

Hi Guyfang I thought I had replied to the man in his thread. To me a thread is the string mom used to sow up the holes in my jeans. I'm not knowledgable as to how to start a thread. I just tried to help him like you do. You were a help to me months ago. If I remember right, I replaced the s-17...

If you check the breaker and everything is good, it may be the solenoid. Check to make sure the kill solenoid on the side of the engine is not stuck in the out or kill position. Make sure your red knob is out on the main panel.

Sir I have cycled the switch. Are there any avanues for service around here? Im in Williamsburg and it shows you in Northern Va.

Thank you for your time. I will try to make sense of the TM. You have been very helpfull.

Yes, with some part, new. It clicks when I push the dead crank up or turn the master switch to run position. Large wires go tot eh glow plug and the starter soliniod.

What about the master switch I mentioned. This unit had a DHR10, not a CHR10 could that be anything.

Dead crank switch in the center, 24.5 left side cr1 and 24.9 on the right Dead crank down to run position, 23.8 on left side 24.6 on the right Dead crank in the up position to crank, 23.9 on the left, and 24.7 on the right.

My Fault. Re read what you said and used smaller pin in socket. Only got under 4 volts in all three pins, X-T-N

Have wiring diagram, not an electrical guy though. I know how to build houses, but will try almost anything.

yes 24+

you lost me with see post 18

cr1 had 24+ on the voltage cr2 had zero

24.9 on both lugs of mt4 crank switch in off position

Also placed dead switch down, and master switch on and only got .2 v on the three pins.

Grounded my meter to the generator ground , tested on battery got 12.4 volts. pushed crank switch up to crank, got no starter movement, and no readings on any of the pins, T_N_X