Recent content by Cwynott

Well after finally getting some time to work on the truck. I changed the fuel filter and it ran fine for a few minutes and started acting up again. I had a spare filter with me and put it on and still isn't running right. The pickup tube all the way to the lift pump is new less than 2 years old...

The local napa didn't have the filters in stock I ordered them will have them tommrow morning. And will replace them and see how it runs.

This afternoon I ran my truck for a few hours and on the way home it began to run rough. Almost like it's out of fuel. It has 3/4 tank the the filters are new. It wouldn't accelerate past 35-40 mph. And was sputtering like no fuel. It would lose power and slow down till it shut off. But then it...

I just put the new pcbox on and it fire right up. Thank you very much!

Thank you I will install the new box first thing in the morning and get back on here. Before this issue came up from time to time I would have to rock the battery switch a few times to get it to turn on if that means anything else.

The pcbox that is on there now when I turn the battery switch to the on position I hear it clicking. Could that be anything?

When I was changing the battery cables I found 569 replaced the end and put it on the 12v side. I'll try the new pcbox in the morning.

I have a brand new one I will put on in the morning. I put 2 used ones on it. Do you think it could possible fry the new one?

Batter switch Terminal 81a has 24+ volts, terminal 459 has 24+, the other 2 terminals have no power coming from them. Pcb box wire 5 has no power when switch in on position also wire 74 has no power when in start position

I just got a new one I ordered in the mail today. I'll try installing it in the morning.

I load tested all the batteries. Then ran new wires from the batteries to the starter also new terminals. Cleaned up all the terminals on the starter. Still no power at the battery switch or starter switch. But there is 24+ Volts going into the pcm. Are there any circuit breakers or fuses I...

thank you i will try that and see what happens.

hello i have a 1990 m925a2. it fried the alternator about a month ago. i replaced it with a delco style one. the other day when i went to go fire it up there was no power. the batteries both have 13 volts, also the wires going into the pcb have 26 volts. when i turn the battery switch i get a...

Check around the filter its dry.

I did check all the hubs they were all the same temepture. The oil did not smell like gear oil. It seems to start at the back side of the motor more towards the driver side