Recent content by dataplatesnet

I'll need a picture of what you want. email it to me! orders@dataplates.net

Thanks DecuesWild11 sorry that took so long, was pretty busy at the time. I can mark places where holes should be, but experience tells me they won't lineup with where the holes need to be. That is why I suggest people drill them themselves. Greg

I'm glad they are working out! I'm searching around to see if I can find a hole punch that will allow me to set the location of the punch. I have a few more sets of these going out the next couple of days. You guys have been great. Sorry if I've been a slower than what I like, I'm trying to...

Allrighty, on my website dataplates.net under the vehicle tab I have the full set with pictures. Also, would the people I sent the sets to drop me an email and let me know how they fit and what not. I want to fix any sizing problems asap. Thanks guys!

Here is a pdf image of everything I've got so far. Ringeltaub did some proofreading for me but see if I've missed anything. Tomorrow I'm doing an entire run of all these plates. I'll take a picture of them and then post the pdf for pricing as well as a photo of the plates on my website...

Thanks guys, I'm guessing a little when I make these. After I see what comes out I make adjustments to what doesn't look quite right to me. I figured the yellow black tranny plate would be iffy. Not sure what process they are using to do that.

Here is what I currently have for the M35A2 in the proper colors more or less. I put a price for the full set.

I thought they came out pretty well. I adjusted some of the fonts a little after they came out. Each of the materials reacts differently so until I run them once its a bit of a guess. I'll add the "rounded corner" part which we call a notch. The samples I had didn't have that but I guess...

I can't add the serial number now that they are done. I thought you wanted to stamp that in. I CAN put a serial number in during the engraving process on any future items. There were 6 plates, the 7 was if I couldn't get 13 inch in the shear and we would make 2 plates out of it.

I could put anything on the plates, not a big deal. I'll have to figure out hot to add a sig. dataplates.net is the site. I don't have all the military stuff on there, I'll work on that.

Hey Gringel, whats up? Yeah I can only do one color at a time, well not totally true I could sublimate them onto aluminum in color (in fact a couple of the ones sent to me where done that way, and the color is pretty much gone, so they must be old, newer sublimation inks are pretty resistant...

Basically I charge by the square inch. Typically $1.00 per square inch that covers the set-up time for making a new plate. After that its .50 to 60 cents a square inch depending on the material. The above is missing a 2.25 x 13 inch plate. Ran out of material. To run all 6 of those plates...

Here is a picture of the M35A2 plates I made today. Ran out of durablack but there is another plate that has the transmission details I still need to do.

I just laid out most of the plates for an M35 A2. The plates that were sent to me weren't originals so I made some executive decisions on the reworking. If you want to see the layouts send me an email. orders@dataplates.net took about 3 hours so I really hope this wasn't for a one...

I'll take some pictures or scan some of the next ones!