Recent content by deercoker

I just replaced both alternator belts with the Dayco's and immediately the passenger side is squealing, did not do it till I changed out the old one, any thoughts?

Thanks

I meant to say it worked up until the day I drove it and the died but that day it was not working

Not really sure but my loadtester has always proven to be working correctly, I will add also in my original post I forget to add that the voltmeter gauge worked up until the day truck died and didn't give it much thought because I have had the issue before even though both alternators were...

Don't think it was according to my load tester, however I changed it out because it was smaller than the back so they were miss matched and the bracket was not sitting on it correctly, I will use it on my boat though, still puzzled how the glow plug relay could shut off the power to the ignition...

Update::: put a new glow plug relay in and a new front battery and she fired right up, thanks everyone for the replies

Thanks I got it towed home now just troubleshooting, I appreciate the info👍

Next question, where could I find one? Napa and the other parts stores have one with two terminals and a harness plug in, thanks

Next question is would a bad relay kill all power in the cab?

No clicking or a clunk with 12 volts to B and C, also no continuity between A and D, also charged the front battery overnight and it tests good with a loadtester

Thanks I will check it in the morning

Have 22.7 volts at right hand terminal marked A, no voltage out of B, C or D, I know 22.7 is low and the front battery is bad but could this relay be bad?

After driving my M1009 for about 10 miles it suddenly died and lost all power, fuses appear good and we tried to jump it but with ignition switch on there are no lights at all as if power is not getting to the switch or not leaving the switch, please any ideas as I am basically stuck roadside...

Thanks Tinstar!

Thanks I will do that in a couple weeks or so! I have another issue now with leaking diff fluid from rear pinion seal, the seal was replaced at a garage for me a few months ago and I am just wondering if they used the wrong seal, any thoughts Tinstar?