Recent content by Deucelander

I've started to install the pass through using the accordion boot. It will take me awhile to complete it as I don't have endless amounts of time to work on the deuce. But here are some photos of the initial cut thru the cab. I started to cut through the cargo box wall but my arbor sheared off...

That's a lot of extra space. Nice job! Is the leg of the roof rack sitting in the gutter and the outer plate acts as a clamp or is outer plate welded to the gutter?

Yes, i just ordered a new data plate for my M109A3. Just send him and email to get the process started.

I sent you a PM, if you have any left. :cry:

Nice hitch on the front bumper. I thought about doing that myself.

Westech, Thanks for the info. I agree with the soot and water looking like oil. That was my initial evaluation as well but i wanted to be sure. I feel better now that someone else has encountered this. The truck really hasn't been run in a year or so. this leak appeared after an hour of running...

FMJ I also encounter a turbo leak after topping off the water/coolant that i don't remember being there before (Coincidence:roll:). My leak is not as noticeable as yours. I pulled the inlet and outlet tubes off and found the inlet to be clean and dry. The outlet's turbo blades were dry but...

CARNAC, Thanks for all the information! Here is what I have; AM General M35A2C WO/W a. Serial Number (VIN number) - 054011684 (on frame) b. Registration Number - NK051E c. NSN without dashes - 23209260873 d. Where you bought it - previous owner said it came from a GL auction in Ohio e...

I am in the process of replacing my rear seals. I have the hub off and replacing the inner seal. TM 209 says to wipe off any grease that is on the rubber seal. However TM 361 says to lightly gease the rubber seal. What is the proper technique? Lube or no lube on the rubber seal that makes...

PM sent