Recent content by dieseler

would one of those tractor kits work in our trucks then?

Where did you find the sleeve and piston kits at? I found a few multis around, it's just that by the time I pay for it and shipping, the dt466 is way cheaper.

Would a DT466 with a rear sump work too?

I've done some searching and was just curious if anyone has actually swapped a DT466 into their truck. My multifuel is on it's last leg and I can't find a replacement close by, but I keep coming across DT466's. I was thinking about 175 to 195hp non aftercooled 466 would make a good replacement...

I've been taking it all the way down to bare metal. I just wonder how far in front of the spring hangar it could be.

I looked in front of both front spring hangers and so far nothing but I keep stripping paint.

Where at on the passenger frame rail? I looked adjacent of driver side rail where everyone else seems to find there vin at.

The tag on the engine is not legible. Only thing I can make out it is White.

Didn't see any tags that I could read on the axles or tranny but they could be painted over. I look tomorrow with some better light. It's just a M35A2 hard top. Tag on inside says for repairs says 9-87 but no other numbers. Number from top is SN 4884 Contract #SP0750-96-C-2381. Is there any...

Well it's not on left frame rail or on the right frame rail. This number was on a tag inside the door frame 9-2320-200-35-1. Any suggestions.

I'll try it again tomorrow but I looked around there too and I took it all the way to bare metal.

That's the only number on the dash and it's not by the pitman arm. I tried all around that area and came up with nothing.

I done searched and read through the threads about Vin location and seen pictures of where it could be located, but I can't find the vin on my frame. The data plate says 4D7994. From what I have been reading I'm not really sure if that is it or not. That number is also on the inside of the...

Thanks, I'll keep that in mind. I can come and haul it back myself. I just thought someone might be dead headed back this away.

I forgot to put a time period. I would need it done in about two weeks. Thanks