Recent content by Dmoneygage

Thank you.

Ok. I'll check that out and get back to you.

Here is the receipt. Alika at Power Train Industries Hawaii a division of Hawaii Driveline Supply knows his shit. I got both shafts retubed, balanced, and new ujoints on the rear for 772$ Very happy with the results.

(1) I have a 1998 M1078 with 225 hp 3116. I don't know but I think it's an A1? Maybe someone can clarify. Are these the hooks and the pin you grease. I was thinking that was where the noise might be coming from. It is loud and unsettling. I'll try the grease. (2) I hope the atf makes a...

I got my truck shipped to me from Oahu to Maui a month or so back. The rear driveshaft was bent so bad like a banana. Guess they forklifted it at some point. The front was bent too. I had them both retired and balanced and just got them them reinstalled. Got a few issues I need to address. The...

My '72 710m looks kinda small next to the m1078 but I love the truck.

Oh man, I haven’t even seen the truck in person yet and I’m still enjoying the hell out of

To ship from Oahu to Maui it was a little cheaper to use the platform than to drive it one the boat. Should come in around $1600. I’ll know exactly when I pick it up on Tuesday after it’s been weighed and measured by Young Brothers. Trucking company has insurance registered with YB so they...

Here is the damage to the mirror and the ding on the shaft

I’ve had the ambulance for years. Got it for free plus a $300 tow. My kid uses it as a playhouse. The Ford van it sits on is wasted. I think it can be turned into a functional camper.

I spoke with John Kopalek at Transmission Instruments. My WTEC III push button selector apparently has a defective display or display driver. The Shifter is designed to operate between 8v and 30v and that if I see anything on the display (like the symbol I’m getting) that I don’t have a power...

Thank you for the advice.

Thank you. I’ll check all that. Hopefully it’s something easy with low voltage.

So the master power switch and push button start the truck now but I am still getting this strange symbol on my transmission push button selector switch. I cannot engage any gears or get codes. Not sure what to do. Don’t see anything in the Tm about this symbol. Can anyone point me in the right...