Recent content by duanejacques

In Bullhead City AZ

I have 8 tires and wheels with the Goodyear Enforcer MT tires and 01/24 date codes. Wheels appear used but newish. Tires never on the ground. Set of 4 2000.00 . Some still have the NSN sticker on them.

no cdr valves. i stuck with the stock hi back seats. most were in great condition. i looked mainly at Yermo Ca. i also recieved the new Revision motors and trans. All were not running and had zero fluids in them. It was like they installed everything but were going to store them until meeded is...

welcome. yes it has been the same for me as ive aquired a M1151A1 {2 of them} M1552c {made from an original M1152A1} and a M1114A1. It wont take you long to get into the swing of things. Any help you need would be found in this site since there are a lot of great people to help you.

I will definitely check that. I do have a new exhaust system that the gov must have installed that is mounted too close to the drive shaft. I've noticed a bunch of wire harness issues that seem routed incorrectly and too close to moving and hot parts. They installed a brand new MTP motor and...

Just banging my head trying to figure out what would cause the 12v wire to the Transmission Control Module to read 6.7vdc. I've checked and cleaned up the battery posts and 12v connections. With the 2 12v wires that attach to the 12v feed one wire reads 12v and the larger one shows around...

I have 2 extra 2100-AB transmission control modules that we picked up. They are still in the packaging if you need one.

Sorry it's been a while, so finally, I had a good 12 code flash for the transmission control module test. I have also found a couple of other things wrong, e-brake was dragging, and I re adjusted the TPS at the IP. I have also changed the Transmission Control Module 2100-AB to a new date...

I'm thinking A0? It's a 1996

yes my truck is the 1996 i beiive that it is the A0 ?

so I had purchased a great running M1078 and noticed when I bought it that the CTIS connector that connects to the CTIS controller was missing. I was fine with it until now. I have done some exploring and found that the connector P110 was cut off and the rest of the cable was pushed into the...

Yes I definitely have the yellow trans light. It comes on with the run lever and goes off after starting. I will do the troubleshooting that you have sent me and let you know what I find. I was kind of concerned about also still having the missing gauge panel since some obvious grounds are just...

Yes sir you are right it's a 4l80

does anyone know about the 6L80 that came in the M1151A1? I seem to have an issue with the shifting = meaning that it seems to need some accelerator pedal release each time I need a higher gear. The fluid is fine and red. I serviced it with a new filter and re=usable gasket. One note is that...