Recent content by Eliteweapons

The black plate specials are always great.

How are those lights working for you? I am going to put a set on my truck and am trying to find a good set that will also fit in the bucket. I got a few, but they didn't fit.

I am concerned about the GROUND arcing to a support piece. As already stated check all the ground connections and wiring in the bucket but also ANY work performed by the previous owner. A new to you truck may have some issues caused by previous work. I am not trying to bash the previous owner...

Keep in mind that the top speed is going to be reduced. Just in case you haven't thought about that.

Could an admin add this to the parts sticky??

My truck was converted to a civy flasher by the previous owner and it finally failed due to corrosion. I used a Grote P/N 44010 solid state flasher for a replacement and it works great as well as being prepared to switch to LED in the future. My picture is too big and won't post.

Is stainless approved brake lines by DOT for trucks? I convert all my vehicles to stainless so if I had that issue I would go stainless if it is allowed.

If you need milspec wire I bought some that were bargain precuts from Allied wire and cable.

I think someone was making blank gauge panels. You may want to see if you can find one of them and maybe change the layout to make the new ones all fit.

Toby, Do you have the part numbers so I can add them to my list of parts, and maybe someone can add them to the sticky for the trans as well. Thanks

I may be missing something here but my plates go on the inside of the rim and not the outside. Those look like different rims than mine as well if you look at the bolt count.

When my flasher failed I replaced it with the one below. It is also rated for led's. Dunno why it added the picture sideways thou.

There are companies out there that make conversion boxes now but they are expensive.

Subscribed

You are just a tease now aren't ya?