Recent content by formula223

Thanks for all of the help. I'm pretty sure, as has been suggested, that the control box is the problem. I've tested the switch extensively and it is working as it should. Grounds and grounding kit are good. Starter and starter solenoid tested good. The bendix is not hanging. The starter...

Ignition system problem on my 93 M998, 6.2, 3 speed. When turning ignition switch from OFF to ON, starter will occasionally engage, WAIT light does not come on. Usually, if I switch back to OFF the starter will stop. However, sometimes it continues to crank in OFF position without engine...

Does anyone know if the pitman arm on a 93 M998 crosses over to a common GM vehicle that I can get locally ? If so, which vehicle ? THANKS !!!

Built 700r4 and a 241c transfer case is the way to go. Fully mechanical with no need to change drive shafts, crossmembers or anything. People say the 700r4 is junk but there are a million drag racers putting 1000hp to them with a mid level build. Way cheaper and easier than the 4l80 and no...

I need two Goodyear MT 37x12.50 R16.5 about 90% tread on 8 lug 12 bolt wheels with run flats for HMMWV. Tread pointing down when mounted on left (driver's) side and viewed from front. I will be there Saturday. Price should be somewhere between $100 and $150 depending on condition.

Unfortunately, they will not ship direct even though the AMG lable had my name and address printed on it. The box went through a Hummer dealer then to me.

I finally decided on 3M Auto Bedding and Glazing Compound #08509 in a regular sized calk gun tube. I asked the auto paint and body supply shops for polybutylene but they all told me they dont carry it anymore. After purchasing the 3M 08509 I read the lable and it says it is polybutylene...

Yeah, I was surprised. The cookies were in a poly bag with the invoice. Nice touch.

Maybe so. I'm not an expert but I can tell you that mine did not. Its possible it may have been replaced but I doubt it as its date marked.

Mine does not. My truck is a 1993 M9989 issued to the Seabees. Very clean truck. The windshield glass on both sides is dated 1993 so I believe it to be original. I'm replacing it only due to wiper scratches. The X-door glass does have the rubberized coating on the interior side but I've...

I'm not absolutely sure but it has the same kind of DOT etching in the lower corner as my original glass. The new and original look exactly alike.

I called several glass shops. A couple knew what I was asking about but didn't know what to use. The others didn't understand the question.

Yep, that's what I purchased. $55 each and shipping was almost as much. I even got a bag of Famous Amos chocolate chip cookies wrapped up with the invoice. I had the same idea about putting the sealer inside the lip of the gasket and may do that. I figured someone somewhere knows the proper...