Recent content by Freedom Land Clearing

I started the process of getting a bed on my M1088A0. The bed rails are just c-channels I intend to set a sources M1078 bed on. We will see how well it all goes over the next few weeks. Lol

I picked up two at Napa last year. Decent price if I recall. John

Thanks, all for your inputs. I’m gonna get it then. Seems like a steal for sure. It seems to be operational without any apparent problems…I let it run for 40 minutes while I looked around. They also have a smaller one, 5KW and it has 169 hours on the ticker. I may look into that one also. John

Thanks, Colt.

Hey All, I have my eyes on an MEP-803A with 290 hours. It’s clean, runs, has no leaks, makes power (at least 120V) and has new Oprima red top batteries and appears to have been maintained regularly as there are notes associated with the maintenance items. Ot starts easily and doesn’t smoke. I...

Awesome—thanks!

I think I found some at a local truck parts store. I’ll figure out the proper size and get it done. Simple! Thanks. John

Hey all, While using a cutting torch on my 5th wheel removal project, someone got a little aggressive and some liquid metal put a small hole in one of my plastic air lines. Is it acceptable to cut it cleanly at the hole and simply reconnect with a push connect? I assume I’d meet a DOT approved...

Haha. Well, I’m prior Air Force. So I guess it helped an Airman too.

Awesome, many thanks! John

I’d like to know if my M1088A0 CTIS has the functionality to automatically switch from cross country to highway based off of speed alone? here’s the scenario… I was in Highway mode, switched it to cross country and the system functioned as it should. All six tires were aired down. We started...

@Ronmar and @GeneralDisorder, that new pressure transducer seemed to be the issue! I installed the 0-100 PSI version, fired the truck up and it worked. A big thanks goes out to all that assisted. John

Their guide does that the tone the way you describe. I ordered the 0-100 as mine is a tractor (M1088) and the stock setup “should” be programmed for 80ish PSI. If it’s wrong, I’ll replace it. I’ll post an update when this gets here on Saturday. Thanks. John

@Ronmar. I verified I have continuity between pins a, b and J on the ECU and the PCU pressure transducer harness pins a, b and c. Also, using the Spicer service manual, I verified that the wet tank pressure switch is opening and closing on or about the prescribed pressures. See the attached...

I am absolutely not opposed to this at all. Do you happen to have a link or picture of the how-to? Thanks. John