G744's latest activity

  • G744
    G744 replied to the thread Instruments.
    Replace the 1819 original bulbs with 24V type 353 bulbs. It puts the filament behind the panel for much improved reading.
  • G744
    G744 replied to the thread Strange noise on m35a2.
    Those damn buzzers can wake the dead! One guy in our group moved to the rear of his truck, used a turn signal flasher on it, and used...
  • G744
    G744 replied to the thread Rear axle change..
    4.89:1 gears will pick up speed, but will be limited by horsepower. If it makes it to 70mph at all, it won't hold it on any hill...
  • G744
    A tiny squeeze bottle with a little gas in it is lots easier on a Diesel than ether. That is, if you can get it into the intake without...
  • G744
    G744 replied to the thread Marine Corps 34052 Behr Paint Codes.
    I used Behr years ago, and "Ponderosa Green" was a perfect 383 green. A truck I painted back in the late 80's still is passable... Now...
  • G744
    G744 replied to the thread 220v 3phase from MEP-003.
    Keep in mind, motors on 3-phase can turn either direction depending connection. If they turn the wrong way, flip two of the three...
  • G744
    Some radiator shops will clean a fuel tank. Also look up Redi-Strip in your area. They have an electrolytic process that not only...
  • G744
    The rest of the tank innards probably look the same. Time to pull it and have it cleaned before a new pump goes in. DG
  • G744
    Silly to mention it, but make sure the engine stop is not pulled out... DG
  • G744
    As far as the G742 series trucks go, they are very much the same. Major differences exist as follows: Gas (early) or Multifuel...
  • G744
    Winches seldom have a positive mechanical hookup for the rope, because if they went all the way out it would reverse start winding on...
  • G744
    I have owned many Mutts over the years, and the A2 was a bit (just a bit, mind you) more stable in traffic. All Mutts can flip, just...
  • G744
    G744 replied to the thread Paint quote.
    If using paint from a MV parts house, be aware the Aervoe brand fades fast out here in AZ, from OD to pink in a couple years. Some have...
  • G744
    G744 replied to the thread Paint quote.
    Yep, I've used Gillespie paint for years on my MV's. Never been disappointed. DG
  • G744
    Boyce has custom, one piece deuce wheels for under $400, and will quote you for custom sizes -...
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website like our supporting vendors. Their ads help keep Steel Soldiers going. Please consider disabling your ad blockers for the site. Thanks!

I've Disabled AdBlock
No Thanks