Recent content by gbww

I am wondering if you have a follow up on the spare tire mount? Is it holding up? Are 3 hinges enough? Where did you get the mount? We are looking at an ambulance that has the doors already, and we have a mandatory requirement for a spare tire on the rig. Thanks for any help Dan

I am wondering if anyone has a mount for re-mounting the spare on an Humvee ambulance. It needs to not block the back doors and step. (The need to open from both the interior and exterior are super important. Any suggestions are appreciated! Thanks Dan

I am wondering if anyone know what type/size of ends are on both sides of the transmission cooler lines. We need to replace ours as we relocated the cooler into the frame rails and now the hoses are too long. Trying to have the hoses made up before we pull everything. The Hose Builder at...

In!

Sorry, I don't have numbers on it. I pulled the part and tool it into Napa and we built it from the parts shelf.

This is mounted on the right side of the wet tank.

Patrick- Thanks for the response. I found a way to fix it locally and didn't end up needing the tank. -Dan

Once again discovered if it aint broke.... Fixed a leak on the main tank, and figured...might as well do them all. Bad choice the wet tank was badly cross threaded. Hit me up if you have one to sell! Thanks, Dan

I am looking for the switched circuit for adding 12v accessories (stereo, nav, etc) that I want to shut off with the ignition switch.

Wondering where folks are finding switched ignition wires? I have a 1997 m1088a0. Only one of the fuses switches with ignition. Any recommendations or spots you may have found would be great! Thanks Dan

Stupid mistake of the day goes to....me! I replaced the heater unit in the dash with an AC unit. When I disconnected the hoses from the engine, I neglected to label inflow or outflow. The core has it marked, just not the hoses from the engine side. Any clues or tips on determining which...

Attempt #1 full fail! Ordered window crank extensions made by strybuc. They are half the size needed. They are a spline with both male and female sides. On to the next plan....

I changed the link. I think that should work. Wouldn't work from my phone, had to use an actual computer.

I am not sure what your reply means?