Recent content by General Kaiser

Hi Thanks a lot gringeltaube I will check it in next week. I'm far from truck for days.

I'm still searching . But I think the fork is out of its place. Taking the hole unit out is challenging too!!😁

Hello everyone Can I just take out front compounents of transfer case (like drive shafts and etc) and open front door for repair ? Thanks

Thanks a lot !! I know English enough to understand technical text 😁

Hi Where are snap rings that can cause the problem when missed ?

Nothing wrong with them!! Everything looked like new except ball-bearings! After rebuild transfer case worked just fine with zero problems until I parked the truck for a while and when drove it again , I had noticed the problem. I think people who was intrested on truck and sat in the truck...

Hi But I had opened the top 4 srews and cover and saw the fork was reach the end and contact transfer case body. Thanks

Thanks a lot ! Could loose fasteners cause the problem? (Not engaging high range)

Ok ! I will do it. Could be better if you have photos! Thanks

Thanks , so thats not my problem. I hope I can fix it without taking out the whole unit 😂

Syncronizer (I mean the gold part in your pics) should move with fork movement ? In my Deuce's transfer case when I moving the lever , synchronizer moves with fork

Linkage is fine ! The skrew is tight and safety-wired! My problem is the fork goes back and contact transfer case body , but synchronizer wont move beck enough to engage high range gear. Is it possible for fork to jump out its place to back and cant move synchronizer back enough? Thanks

Hello everyone I had rebuild my Deuce's transfer case in last rew months . No problems until yesterday I was taking it to shop for taking out stuck screws of windshield , I had noticed high range didn't engage. When I was trying to hold the lever by hand , the only thing that happened was...

I bought NSK and Nachi bearings.

Hi Not at alll with your help! Thanks a lot. But I couldn't found Made in USA bearings and bought Japanese ones. But good quality bearings