Recent content by Ghost1986

I appreciate the help.

Do you think the psi limit is too low ? It says 116psi max

Man I know this post is old as dirt but I'm having trouble finding this solenoid, they are all out of stock. I want this setup!!

Won't do anything as in it's in high, but won't shift into low ( pushing the button on the lever doesn't release air in the stack) looked it all over but it might be the pcm or lack thereof.

If I jumped out my pcb. Completely bypassed it( it was bad) would this cause my transfer case not to engage? It won't do ANYTHING. Any ideas?

923a2 5 ton. I don't mind the fresh air , it's the rain that drops in down on my gauges. Then they fog up😑

Looks like they are out of stock😢

Yea they look similar, but will they fit my m923a2 5ton?

I know this is an old thread but where exactly did you get your windshield frame to body seals? Mine leak so bad.....

I'm sorry I didn't say anything in my last post, I just replaced the batteries thinking that was the problem. So update. I can connect the pcb and jump the two larger wires and it fires and everything works.( I remove the jumper after it starts) Sometimes I can turn it off and it will start...

Help! I'm new to the forum, don't usually like asking for help, but I'm stuck. My m923a2 (just bought) is having issues starting. Sometimes you turn the batt switch on and all that happens is a click. No gauges or anything else. I took my pcb apart and it looks just like plode's picture on here...