Recent content by Greatthumper

This is what I was talking about

Nope. Not that. That is (Plate, Mounting (A3014550-1)). I have that for the speaker. I will take a picture in the morning. Thanks for looking

My 1008 was a radio truck at some point. I am gathering items to return it to that config. My truck has a mount on the front of the bench seat. CARC green with two wheel knobs on the plate. It matches the angle of the seat. I have not found what this is for. Any ideas?

Ok, Hope this is the right area. I have for the past 10+ days been dealing with Flashing Gen1 and Gen 2 lights as I travel at highway speeds. Gen lights flashing alternating like a railroad crossing sign. The amp gauge shows to be charging (all in the green). Then it goes away for a few days...

The two pins that are damaged are circled in red. Lower right side.

Got it loaded.

Can the trailer harness be repaired? I have two pins pushed into the harness. The part I am referring to is "intervehicular cable, NSN 6150008306672. Page 3-1 of the TM. I am willing to give it a try, whats the worse that can happen. If I break it any more I still have to replace it.

All righty. This is my question. I picked up for my M1008 a cargo cover and bows. Thank you “lmcdncn” For the pay it forward kit. The cover is a much heavier, dark green and has plastic disks reinforcing the corners. I like it but needs repair. I bought a new cover for my truck. The new one is...

Cover your Ass! My wife had the same type accident. 3 months later THEY sued with a whole new story. Thankfully the witnesses came forward and straightened this out for the court. I also got sued many years ago for an accident that did not happen. Insurance settled out of court, I think the laws...

Thank you Patracy! Your links identify the wire. Now I know!

I found a wire disconnected. I have looked for about 2 hours and can not find what it goes to. Is this just "extra" or is it to something? I had a horrible electrical Gremlin in the truck for the last week. I found this looking for the problem. The Gremlin was a loose ground on the drivers side...

It was the starter relay. I did the Doghead Conversion. Truck started right up after I pulled the starter and replaced the relay. Thank You all for your help. Thank You Doghead for the conversion.

Thank You, Thank You, Thank You, I will start malfunction #5 ASAP.

I turn the key and nothing. Starter does not engage, starter does nothing. Checked all fuses in the box. Charged both batterys. Tried again, same result. Any thoughts?