Recent content by greg2560

You would never think it had a dump kit installed looking at it. Stock height yes.

m35a2 dump Got it going not to bad... Had the kit for the dump over a year but it is now installed.. http://youtu.be/iiwdMDHppUM

looks like a delco with a 24v reg installed

fuzzy now you remember the truck... Ya passenger glass still broken.. but hinge is fixed lol...

ya I think it is like 1/8.. thanks for the info

I bought the tuck few years back from Fuzzytoster... To make a dump out of it.. Have only had small problems with it had to re o-ring the hh and rebuild one wheel cylinder.. Other than that good truck.. I bought a ph516 hoist for the dump about a year ago ..ya it sat around some time but it is...

??? it is a rubber joint...

wow that is close....dog bone go bad you are screwed … Nice bumper jack lift lol

Nice got to have to good shop tools to work on junk and make it work. Build it, buy it or what ever it takes.... Fixing to start dump bed install on mine just got to get the time to do it... Got the dump hoist in 2 months ago!!!!

yes a plasma water table...cnc Never seen cutting with water

Nice job on the adapters... Made some like that for my 4040 JD tractor to put IH wheel weights on the rear.. to add about 500lbs per wheel.. IH wheel weights are cheap down here in S TX... I am guessing you cut them on a water table?? And punched the holes

Are you running a thermo coupler gauge??? If that is what you are running it should be pretty close to what temp it is.. If you are running a electronic gauge it might be off... Make sure you are using the correct sending unit and the gauge grounded good... Mine is stock and it showed to be...

looks like you need to add some air ride.. that would be nice... other than that looks good!!!!!

If they got them from the forest service that is gov trucks right

there are no plates on the trucks will have to check with the FD whos trucks they are... My guess.... hey the are mine in my county lol so they are mine to sell