-
Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!
grywitt's latest activity
-
Ggrywitt replied to the thread Mep 831A load issues.Sorry I know i jump around a lot. I try not to. One more thing. I never saw any fue
-
Ggrywitt replied to the thread Mep 831A load issues.I did make one troubleshooting mistake when making this new video. It might be that sitting with sea foam made the difference and not...
-
Ggrywitt replied to the thread Mep 831A load issues.https://youtube.com/shorts/tAAsPIdXzy8?si=jxNNoynAacGKmqvX Here I think is proof and hopefully a clue for someone more knowledgeable...
-
-
Ggrywitt replied to the thread Mep 831A load issues.
-
Ggrywitt replied to the thread Mep 831A load issues.I just realized I even took a picture of my thoughts on how to check the spray pattern. Is that how? Like ice got it?
-
Ggrywitt replied to the thread Mep 831A load issues.I do keep it in a conex that has good seals but I definitely will rodent proof it if and when it's susceptible to them. I already killed...
-
Ggrywitt replied to the thread Mep 831A load issues.Well i figured out the debris. Just a lot of sticks and twigs,leaves ect down by the exhaust and close enough to get burnt then fly out...
-
-
Ggrywitt replied to the thread Mep 831A load issues.Thank you for clarifying. I did pull out the push rods and they looked good. I didn't roll them on a flat surface. I'll keep digging in...
-
Ggrywitt replied to the thread Mep 831A load issues.I didn't get far nought into the engine yet to check the tappet under the push rods. Do i pretty much need to remove the engine from the...
-
Ggrywitt replied to the thread Mep 831A load issues.Thank you for the suggestions. I will work on the things you mentioned. So the injection pump only has one shim. Is that normal? Seems...
-
-
GSo, yes, that's more smoke than I would like at the loads you are adding. When you add loads, I can hear the engine respond, and it...
-
Ggrywitt replied to the thread Mep 831A load issues.I didn't add the fan load specifically but the amps the load bank says it's drawing match my clamp meter to the 10th of an amp so the...
-
Ggrywitt replied to the thread Mep 831A load issues.I thought I might have found something. When I checked the valve clearance it seemed pretty off one pretty tight and the other loose but...
-
-
Ggrywitt replied to the thread Mep 831A load issues.For a little more description. When I got it the reason it wouldn't run is a rat called it home and had chewed the wire to the fuel...
-
Ggrywitt replied to the thread Mep 831A load issues.https://youtube.com/shorts/dJM055cDXl4?si=9Aorlz8xkTHs-XrD This is a video of me loading it to 3kw. At 3kw she blows black smoke and dies.
