Recent content by gscales123

I appreciate the sticky. I didn’t know they did this in 2014. I though it was much more recent than that. I’ll try to figure out how to take down the post.

Just got this Humvee finished and was looking at registering it in Oklahoma. Lo and behold they only want to register it as an off-road. (Big red stamp on SF-97). Anyone have any back ways of getting this done. I know I've seen Humvee driving around with a plate. Even checked on getting it...

Went over all the wiring cannot find any bare wires other than in the pics from the meltdown, not sure if the whole problem was in the phase watts switch it is frozen in place. Not sure if i should try to fix, it has been nightmare sense i bought it. Diesel going in oil, fixed that twice...

Both panels was bolted on I took them off to inspect. I will look more at the harness see what i can find. This is the first time i noticed the spliced wire in pic 5 Thanks

Ok Thanks Will go take some pics

Hey Had a meltdown on my mep 006a. I started it the other day and run it about 10 minutes under load while setting my bandsaw mill. 40 hp mill motor and mep run perfect. Turned them off then smelled wiring burning, found my alternator smoking bad inside of it. I unhooked the wiring from...