Recent content by Heavywrecker

Not sure if I'm sold on the synthetic yet, put some real abuse on wire rope and always cared for it with trans fluid never had an issue, seems funky to pull hard on something with a actual rope lol Sent from my iPhone using Tapatalk

Ours is 3 part also Sent from my iPhone using Tapatalk

Thanks red Sent from my iPhone using Tapatalk

You guys rock Sent from my iPhone using Tapatalk

What's a guy have to do to get the winding pulley on the drag winch to pivot? She's seized up Sent from my iPhone using Tapatalk

The underlift, (tilt, up/down, and in/out) side puller winchs in and out, front stabilizers up and down, and rear stabilizers up and down Sent from my iPhone using Tapatalk

I'm going to make a reinforcement collar around the end of the receiver and make it so you can't pull them out accidentally. Also have to add adjustment pins, was thinking about using cam locks but I want to be able to pull on the leg at the shackle and don't want it breaking the cam lock...

This is the final cut Sent from my iPhone using Tapatalk

Sent from my iPhone using Tapatalk

Adding some new stabilizers to the side puller to make setup easier! Sent from my iPhone using Tapatalk

Anyone have a pic of all the warning and rating plates on the control station? Sent from my iPhone using Tapatalk

Just the lathe was built for the war, the Bridgeport is an 80's model Sent from my iPhone using Tapatalk

Not bad actually seems normal! I'll have to post a video once I get it all done Got the side puller attached today, going to modify the winch location a little bit and the. It's onto modifying the legs on the side puller and onto the rearend Sent from my iPhone using Tapatalk

Sent from my iPhone using Tapatalk

It's a Hendy, bought it from a school that was getting new equipment, also have a big Bridgeport mill for playing with this stuff, the lathe was made in the late 40's I believe it says on it, something to do with military war production Sent from my iPhone using Tapatalk