Recent content by hedelta

Been getting my m1009 road ready again been sitting for a while. Having issue with drivers side marking light and the running light under the headlight. They both blink when I hit the turn signal. I changed the bulbs and replaced the fuses but kinda stumped. Any input would be appreciated...

The guy I bought it from has a big book of info on this type of boat and I will share as soon as it becomes handy. Also I have a friend in the navy looking up the old Tms for the boat. I was doing just a bit of web browsing and I found this http://archive.hnsa.org/doc/boatcat/cat-0058.htm That...

All steel hull. The cabin was added on but not 100% by who. Has a 8V-71 and it is a V drive

Today starts a new build for me. Since I couldn't find a place to put this I figured this was close enough( if not please move to correct spot). Just got some new Iron. Not much info on it as yet but it is to the best of my knowledge a 36' uniflite that was used by the navy. She has some holes...

So basically I should just run larger wires to the bus bar install a larger bus bar then continue on to where I will install the new slave port.

I plan on using it for MRE heater, impact and of course when im too lazy to turn the truck around use it to slave my or another persons vehicle.

Thinking on adding a slave receptacle to the rear of the 1009. I would like to just extend the wires from the radio bus bar. My question is, is the wire too small to do this? Or anything else that woulk prevent me from doing this? Thanks for your time. Sean

I had a great day. Im gearing up for next years shoot.

Im ready, got more salutes ammo and some more targets. bringing 2 friends with some full auto goodness with me.

I wont have any trucks there this year. Looking forward to hanging out with everyone stop by for a beer. Looking for some cheap ammo cans.

It wouldbe interesting to see a commercial unit that is 24 volt. I dont want to burn the truck to the ground.

Has anyone here installed a remote start system on a blazer? If so, is it stil a 24 volt system?

Got the wheel bearings and shocks on the front today.

truck would not start so I did the doghead mod as well as replace the other 2 two relays since I had the plate down in view. I also replaced the fuel filter and filled the tires with air now headed to go and get a front end alignment.

oh I see I think she has a set of knuckle dusters she uses to keep Matt in line and I do not think she will hesitate to use them on anyone else.