Recent content by HeisenBob

Of those, the only item I haven’t replaced is the card.

I’ll look for that one. I did the block that’s on the driver side/under the dash area.

I need both myself. Driver and passenger

Wait light has been an issue on my rig for some time. It is very inconsistent. The past few days, I’ll turn on the key and the wait light is off with the relay under hood staying silent. Voltage also doesn’t drop. When I start the truck, the wait light immediately comes on and the relay...

Subscribed

I haven’t had a chance to tear in the wiring but the past two days have been warmer and the cycling has been going away after the truck is good and warmed up. Could it be that the thermostat is too low and I need a hotter one?

I put about 8oz in half a tank of diesel Andy then I filled it up and added another 16oz. Any tips on getting her freed up and running again besides waiting until it warms up? I don’t really like that I had to leave it at a customer’s business.

We’ve had single digits this week. My CUCV froze (fuel gelled) while idling on a job site yesterday. I put additive in the fuel as well as a new fuel filter. I was using cardboard to block the radiator and the defrost ranges from 100-120 degrees. Anything I could have done differently?

Yeah the old one did it as well. I’ll have to try and trace the wires from the sensor the the card. The two wires have electrical tape so could be an issue with the connection somewhere. I’ll check and report back.

Update: I went to town about an hour ago and it took a few times cycling the GPs to fire up. But I let her sit for about 20-30 min to warm up and I blocked off the grill with cardboard. When I came outside to leave, the the GP card was no longer cycling and off I went. After a few minutes on...

I just checked resistance on the one I pulled out. Showed 9000+ in my garage. It’s 5 degrees outside but probably a little warmer in the garage. I brought the sensor inside to test warmed up and see what it reads. It’s definitely working. I tested it under hot water and cold water and it...

Looks like the sensor I bought is the correct part. Is there a chance my GP is not functioning properly?

Yes that helps me greatly! Thanks I’ll dig in and see what I can find.