Recent content by huskyrunnr

The amp is mentioned in the thread title, Ultralife a-320v1. Downstream of the amp for me is a diy cable, 12 volt battery and a dc-dc 12-24 volt converter. The military uses a BB-2590() battery usually, but there are other power sources they use that I’m less familiar with. The cable for the...

The power connector on this amp has three pins. A is +24v, B is ground, but can anyone tell me what pin C is for? I’m thinking a remote power on line but I don’t want to go hooking up voltage Willy nilly without knowing for certain what voltage or signal that line is for.

I was testing a dual wheel setup on the M101A1 trailer. In my hands, the wheels, mounted with superlugs, do not have enough offset to gang together. However, the lug holes of the Budd wheels are chamfered on both sides as if they were made to be able to flip around. My question is why are they...

I've done this a couple of ways off the truck alternator. One way is what blybrook describes. I had to put a relay and fuse into the power dist. box under the hood of the truck and then tie into that line with the "trailer tow battery" line on the 7-pin connector. The other way, which will give...

2INSANE, I started kicking around putting my old '67 8'NCO on a trailer about a month ago and of all the examples out there, I liked the looks of yours the best. I ended up with mine sitting on an m101a1 and I am thrilled with it. It is so much easier to load the camper on the trailer than on...