Recent content by Indyharleyguy

Yes, it is an M1008. It's hopefully stopped raining in the Indianapolis area and will check the PSI today. Thanks. Sent from my SM-S908U using Tapatalk

i'LL CHECK. iF IT WAS U JOINTS WOULDN'T I'll check these out. If it was u joints it wouldn't stop would it?

yes seems to happen after sitting a few days. I'm going to check the pressure after it stops raining in Indy area

I was thinking transmission until the fluid get run a little bit? I have been driving a few times a week for the last 6 months.

Yes it does start after sitting overnight. I have HumVee tires on it. It does ride a little rough right after driving but this is a different feeling to me,. I'll have to check the pressure.

Hi I've got the violent bouncing when I hit 40 MPH. I slow down to 20 MPh and it stops. It last maybe 5 minutes then it stops. It drives fine after that. It seems to only happen when it's cold? I've already had the transmission filter and fluid replaced, the vacuum gauge on the top of the...

Hi Again. I've watched some videos on how to replace my wiper blade switch inside the steering column. I think it's beyond my capability. Is there anyone within a hundred miles of Indianapolis IN that I could hire to do this for me?

I'm tearing into my old truck tomorrow to see if I can figure this out. I'm thinking the Standard Ignition 5 Terminal Windshield Wiper Switch is what broke?> Hoping to see if I can get it off my old truck. Not sure what tools I'll need until I try lol

My ignition switch seems to be working so not planning on touching it.

OK thanks. I've never seen a tool like that.

Hi not sure what you're talking a compressor tool? Can you send me a link. Sent from my SM-T580 using Tapatalk

Now, neither turn signals work, and the left one did right before I accidentally broke it. I've already ordered the part inside the steering column, thinking it might have been bad. But the black plastic part the turn signal lever connects to appears broken. I haven't found what that part is...

Thanks. It appears the turn signal lever is not the broken part but the part it attaches to? My windshield wipers and washer still work, just not the turn signals. Any thoughts?

Hi All, I have a 1984 CUCV and I broke the turn signal lever,. The lever just has the blinkers/turn signal on it and the wiper/washer function on it, no delay wiper, however it would be great if it did. Anyways, I've read some threads and watched some YouTube videos and don't see anything...

Thanks, I'll try that. Any suggestions on how to make the doors themselves close better? Sent from my SM-S908U using Tapatalk