Recent content by JeremyDM

Thanks for all your help! It was the switch that was locked up. A little TLC was the trick and maybe a bit of electrical contact cleaner spray! Working the shaft back and forth with vise grips on it and using some inward pressure while turning and WALA it started to “CLUNK” going into each...

Thanks for all your help! It was the switch that was locked up. A little TLC was the trick and maybe a bit of electrical contact cleaner spray! Working the shaft back and forth with vise grips on it and using some inward pressure while turning and WALA it started to “CLUNK” going into each...

Thanks for all your help! It was the switch that was locked up. A little TLC was the trick and maybe a bit of electrical contact cleaner spray! Working the shaft back and forth with vise grips on it and using some inward pressure while turning and WALA it started to “CLUNK” going into each...

Thanks for all your help! It was the switch that was locked up. A little TLC was the trick and maybe a bit of electrical contact cleaner spray! Working the shaft back and forth with vise grips on it and using some inward pressure while turning and WALA it started to “CLUNK” going into each...

Thanks for all your help! It was the switch that was locked up. A little TLC was the trick and maybe a bit of electrical contact cleaner spray! Working the shaft back and forth with vise grips on it and using some inward pressure while turning and WALA it started to “CLUNK” going into each...

Thank you for the advice I will try when I get some free time

I don’t have a manual for it if that’s what I have to look in

Can you post a schematic for that switch also

Ok thanks a ton for all the information! I will check the knob and shaft first. Pulling that all out looks like a dam nightmare I don’t want to be in. Do you know of anywhere you could get a new switch I’m sure they are probably pricey too.

I don’t really hear anything at all to be honest but I can get it to go to each position. Is there a way to take it apart or free it up?

Even though it turns could something still be stuck within it? Bc it’s acting like it’s in 1 phase 120v with the readings I’m getting right? Or is it anything else it may be? I know like nothing about this machine.

Thank you! I mean it does turn to each position but doesn’t really click or anything not sure if it is suppose to. For 9 o’clock and 3 o’clock you have to turn it past it first.

Thanks for the reply back! That’s what I was possibly thinking or just stuck in the 12 o’clock position. So I guess I would then ask how or is there a way to find that out or free that up in the switch? Taking it apart or something or do you just have to get a whole new switch?

Fired up this generator for the first time since living at this new home but only getting 120v out of it. It’s showing it’s on 1 phase 120/240v on reconnecting switch. Running at 60hz and showing 120 volts on ac voltage gauge on the front I test with multimeter and get 120v from L1 to L3. Test...