Recent content by Jericho

Could be. Are you near show low. ?

Well. My m931 A2 is at last fixed. The rear most axle top loader diff was destroyed. It was impossible to see the damage until I pulled the assembly. You couldn’t see it thru the inspection covers. Too make it more confusing. Sometimes it would rotate fine for hundreds of feet before it...

Just a quick question for some of the hemit guys. Are the hemit rims interchangeable with sn M-915. Looking at an upgrade to a fellow owners 915. He is looking at hemit rims. Will they fit ? Five tons. Deuces. Goats m 38 s no problem. I know very little about hemits. What’s a good rim...

Some of you May remember my last post on this problem. My truck sat for a year during covid and a series of surgeries. Went to move it. Appeared brake wedges were stuck. ( not unusual ) Beat on the hubs. All four were stuck. Got all free except one. Dropped it into low and pulled tire...

Well guys. Been a long time. Was headed right out to pull that wheel the next day. Went for a power walk with my wife in the early morning. Had a heart attack. , don’t have a heart attack in early covid. Was two months before I was seen by a cardiac specialist. 28 days until I saw a real...

Thank you very much sir

Your always good for solid advice. Thank you sir. Tommorrow s job Thanks again.

Hi Wes. Yup. Need to pull the rear tires and the brake hubs. Still looking for my. Won’t go more than five feet back and forth issue. I had the stuck brakes issue. Finally got the wheels to turn. But in the process damaged something. Truck will only back up and go forward about 5 feet...

evening guys and gals just spent three hours going thru all the 900 series TM /TO s looking for the instructions for super single A2 configuration tire and rim removal cant find it , have read it before Any one have the TM number and page paragraph

Thanks Simp. ! If your ever in NH. Or AZ. I think I owe you a few. !

how much work is involved in converting a non CITS NON ANTISKID axle to cits anti skid configuration ? is it worth the effort ?

evening gents. Interesting day so I pulled all four rear wheel drive shafts. gently tugged the truck on to a flat spot with my wifes jeep felt no resistence. keep in mind , all four wheel drive shafts are out t- case in high , so front wheels arnt engaged. moved it about 50 feet...

Simp your quick !!!! does it sound like a xfer case failure to you ? if it were my old 700 i would be looking at an axle drive shaft Getting dark here will pull it in the morning and get back to you , thanks for all your insight guys