Recent content by johniz1967

I am finishing one of these steps this week for someone and can get started on one for you soon. Do you know if yours has the hinges and lanyards? You should be able to see from the pictures of yours. You can email me at johniz1967@yahoo.com

I found someone local that let me take measurements and used craft paper to make patterns for the side plates. I then made a set of rear steps for the one I am working on.

Post pictures as you go.

Thank you for allowing me to come to your place, disassemble and measure your step so I would have the patterns to make mine.

Finally finished with the step and also had to fix the spring dampener.

I am in the process of building a rear step for 2001 HUMVEE A2 Ambulance. This HUMVEE is going to be sent to Ukraine by a local non profit (Ukraine Defense Support) supporting Ukraine with Vehicles, medical supplies, DJI Drones for patrols and reconnaissance and other equipment. I hope to have...

Thank you for the CV boot information. But the seal i am talking about is inside the gear reduction unit where the halfshaft axel goes in.

I need to change the seal that goes around the half shaft on the rear of my M997A2 with 12k gear reduction. I know it's that seal because it was bought missing the rear rh halfshaft and I noticed the seal was a bit deformed when I installed it. I would like any tips or links I can get as to how...

This looks like the steps from amazon. There are many different ones that look like these https://www.amazon.com/gp/product/B0924TD5BX/ref=ewc_pr_img_1?smid=A2MOBBHRX7CB6B&psc=1

Hello and thank you for the write-up. I am helping work on this one. I think it was the one in Woodinville and it has been towed to a shop in Monroe a few times. We made rear doors out of plywood then bought the actual doors but they have no hardware. I am in Everett and would like to come...

Where you at in Washington? Could you take some measurements and make a drawing?

Thank you for the great information.

Does anyone know if I could buy the M997A2 Ambulance rear steps or if there are drawings / plans for someone to use to build a set. I may try to make a set myself. These are the some pictures and diagrams I have found that I may use to try to build a set.

Thank you for your reply. This forum is a great resource. The only manual I could find online is over 800 pages and I tried doing a search in that document but could not find what I was looking for. The links below are for a 10K Half Shaft that list a M997A2 in the fitment list...