• Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!

  • Microsoft MSN, Live, Hotmail, Outlook email users may not be receiving emails. We are working to resolve this issue. Please add support@steelsoldiers.com to your trusted contacts.

Recent content by joshua bebbino

  1. J

    M1008 brake switch

    So it’s attached to my right blinker , a green wire then to the white and black wire on the brake switch . No power to the orange wire or black and white
  2. J

    M1008 brake switch

  3. J

    M1008 brake switch

  4. J

    Right turn signal/brake lights

    Got the right turn sing light working by dis connecting this connection in the picture , now right works , still no brake lights tho.
  5. J

    Right turn signal/brake lights

    Also no stop lights
  6. J

    Right turn signal/brake lights

    Hello all , trying to wire a 7 pin plug in , first wanted to check the lights before I started , got no right turn signal , running lights work and hazards work, I checked for power at the green wire coming from the front at 6 wire male and female connect , got power there for right turn , then...
  7. J

    M1008 brake switch

    it does switch ,at first glance I thought it was some kind of switch but wasn’t sure what is was for. I couldn’t find anywhere that showed a yellowwire tapped into that black and white wire for the brake switch.
  8. J

    M1008 brake switch

    Hello all, does anyone know what this is, it’s spliced into the black and white wire that goes to my brake switch. Was looking to install a brake controller and found it. Wasn’t sure what it was for. Yellow wire hooked up to something then spliced into the black and white wire. Any help would be...
  9. J

    Manual glow plug wiring

    Also, I just changed the glow plugs but voltage was checked with a multimeter as well as a test light
  10. J

    Manual glow plug wiring

  11. J

    Manual glow plug wiring

    yes voltage was taken with a multi meter, there's 3 red wires connected to the top of the relay, the top most one goes to the gp switch, then next one below goes behind the air filter to a rectangle looking thing(I guess this is the resistor, then the final red wire goes to the top bus bar...
  12. J

    Manual glow plug wiring

    I will upload pictures shortly, I just checked the voltage at the top of the gprelay and without the key in it was getting 12v and with the glow plugs switch engaged also 12v.
  13. J

    Manual glow plug wiring

    Glow plugs are getting 12v and just changed the glow plugs , still no start, checked the batteries both have 12.8v , also checked the volts going to the starter, that was 12v , is that correct? Fuel filter wasn't clogged
  14. J

    Manual glow plug wiring

    10-4, I will check the volts to the glow plugs in the am, if there getting 12v I will change the plugs , if not I will try to figuring the restistor thing out, while I get the new plugs I'll also throw a new fuel filter on to cross something off the list, I will report back the status after all...
  15. J

    Manual glow plug wiring

    Yes, you are correct , 1 red wire going to the switch it's a smaller one, 1 red to the bus bar , and 1 behind the air filter, truck had been converted to 12 volt. Bottom of the relay has 3 orange wires. (2) big ones and (1) smaller orange wire. Then a small black wire on the front middle of the...
Top