Keith_J's latest activity

  • Keith_J
    Keith_J replied to the thread Fuel issues.
    Noticed that. Inventory dropped by 1. Realize it is shipped by the vendor, that being whybee adventure. Good ratings. But the trip...
  • Keith_J
    Keith_J replied to the thread Fuel issues.
    Sealey TL95. 168 doll hairs plus change from the usual scumbags. That is a UK brand. And this is an E-dapter kit which makes a...
  • Keith_J
    Keith_J replied to the thread Fuel issues.
    Driver side engine by the harmonic damper. But unless you have a diesel pickup timing light.. The noise will get bad before the timing...
  • Keith_J
    Used the 1031 to go on a parts run for the daily driver. Which was an excuse to drive a few miles. Tested my heater control valve...
  • Keith_J
    Just about done building a 40X60 shop to keep both my CUCVs in and a few other toys.
  • Keith_J
    Keith_J replied to the thread Fuel issues.
    How many miles on the odometer? Any chain slap noise from the timing chain cover? This is noticeable at idle speed when the timing...
  • Keith_J
    Keith_J replied to the thread CDR Valve.
    Perfect test method. It is a pressure regulator so a diaphragm and spring work together. Most common failure is rupture of the...
  • Keith_J
    Keith_J replied to the thread M1009 engine difference.
    The only differences are the injector pump internals. Most vehicles have had the injector pumps swapped. That is on the engine side...
  • Keith_J
    You inspect when you have it apart. You know it should be replaced when the chain slaps the cover. You can hear it.
  • Keith_J
    Parts manuals are the -20P and 34P. The-20 is the unit maintenance so it covers most brake parts. Be sure to follow the correct UOC...
  • Keith_J
    Keith_J replied to the thread Very strange gen 2 problem.
    The 2 relays by the starter relay are for the blackout light system. You have to take the dash cover to see the alternator relay...
  • Keith_J
    Keith_J reacted to Sharecropper's post in the thread Water Pump Bolt / Crossover Pipe with Like Like.
    I have a priming tool that fits into the vacuum pump hole and is powered off a drill. You are welcome to borrow it. It will flood the...
  • Keith_J
    Keith_J replied to the thread Water Pump Bolt / Crossover Pipe.
    The timing cover to engine block and water pump to timing cover are sealed with an anaerobic acrylic sealant gel. Similar chemistry as...
  • Keith_J
    14071080? Figure 31 in the -34P. You have to see what it first secures to the engine. That would be the coolant pump. I was the...
  • Keith_J
    Keith_J replied to the thread Whoa Buddy !.
    Instead of fiddling with injection quantity, why not add methanol at wide open throttle? Yes, you will need a big tank. This could be...
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website like our supporting vendors. Their ads help keep Steel Soldiers going. Please consider disabling your ad blockers for the site. Thanks!

I've Disabled AdBlock
No Thanks