Recent content by Knottofs

What are the "Air lines / Vent lines" that go to one side and out the other side of the Distributor for? When I bought the truck most were closed off with bolts stuck in them. Where can I find a diagram of the venting system? Thanks, Nate

I has an electric fuel pump mounted on the frame behind the cab and clear filter under the hood you can see the fuel pumping.

I have a All Stock M715, I just on the farm. It has a brand new distributor, wires and plugs, fuel pump and carburetor. I need it to sit there and idle at times. After about 5-10 minuets of idling, it cuts out and will not start. After about 20 minuets she fires right up like everything...

Electrical Issue No Power going to the Coil, Batteries all charged, and turns over just fine. Any Ideas where to start looking?

What weight Transmission and Transfercase oil dose the M715 use? Thanks, Nate

Do they have the sand packed / glued in the bottom of them?

Replaced the Distributor "Which worked" With a newly rebuilt one. Now im not getting any spark. 24.7 Volts are going to the coil at its + side. How do i check and see if the right amount of power is leaving the coil? Also, then put old Distributor back in , and now im now getting any...

On the back of the Carb next to the block, Is a small copper pipe that wraps around the engine, What is it? "The light's not good enough to see out there right now, and the flashlight just took a dump on me." Can it be disconnected and blocked Along with the old im guessing pipe that goe's...

How do i get to the TM 9-2320-244-34 Chapter 4,? Thanks

It ran good prior the carb work just slow acceleration.

How much for the kit?

Carb work Mechanic said too much gas going into the card, so he readjusted the float. Now slow acceleration and back fires when turned off.

Rubber Gasket Anybody know where I can get ahold of the rubber gasket in-between the carb and the air filter? Thanks’ Nate

What is the Rubber hose, about 1 ½” wide that is on the right side of the engine next to the oil filter” if your in front of it” that goes from the bottom of the block up to the air filter? It has some kind of connection tube on it about ¼ ” wide that connects to a small pipe that looks like it...

Dose anyone know what the electronic ignition pickup coil is supposed to Ohm out at? My mechanic asked me.