Recent content by lino

I made one a couple years ago.. I think there are more details in the build thread:https://www.steelsoldiers.com/showthread.php?135439-I-beat-the-fuel-fitting-And-a-thread-for-all-the-other-mods-to-my-deuce/page4 It is power bleeder "ready" - see second pic.

Is the spare going to live on the roof of the cab?

Ahh. I didn't realize the coolant and injectors came into contact. If there are contaminants in coolant, they are not visually detectable. It also smells like coolant (not diesel). I'll pull some fuel off the bottom of the tank this week to see if there's any coolant in there. And study up...

Hey All, Still working thru initial diagnosis on my 1078. One of the more troubling issues/symptoms is that the radiator cap is immediately pressurized (and venting) upon starting engine. There may be other causes (that I can't think of), but that tends to point to a failed headgasket (or...

I thought about tapping it harder, but I didn't have a hammer within reach, so I tried Ronmar's method. At the test points I got 27.7V and at the NATO port I got 28.8 Seems like all is in order (except gauge). After about a 20 min warmup, the gauge was reading correctly. Thanks all.

Hey All, Another question.. I'm trying to get ahold of a PTO and hyd pump for my 1078 so I can run a crane. The winch parts would provide correct flow rate and pressure. Digging thru the parts list TM I get: B550133364 for the pump (Can't seem to ID brand) parker p/n 276XMFJX-D5XK for...

That's the first thing I did. Always tap the gauge... Didn't work though.

Hey All, I have a '95 1078 that is showing some odd symptoms... To start with, I don't use it much (right now), about 10-15 min every couple weeks. I don't have much time to work/play with it, so I keep usage minimal until I understand all its quirks. So, starting a month or so ago, I...

Hey Rustystud, I'm not sure if I should reply or just keep quiet. No progress to report. The prototype is still working well on my truck, and a few months ago I made the small updates to the CNC code that I wanted to make. But, I'm working 60+ hrs per week right now and that...

Whoa.... Has it been that long... Seems as though life gets in the way sometimes. I'm not gone. Just busy. Been working on a broken excavator I bought recently. Don't give up on those filters (but don't hold your breath either). I have all the materials and presently have hopes to get...

Ha! Sorry about the radio silence folks. Been busy around here. And the view ahead looks pretty busy too. So the status on this: I have the prototype running on my truck. I wanted to get some miles on it before I made the next version. Last week I ordered the material I need to make several...

The modeling I've done so far has been in ProEngineer. However I'm switching over to Onshape (see www.onshape.com). I'd be happy to share the models I have, though I have very little of the frame modeled. I need to model more as well, because I'm getting started on converting mine to a...

I sure do enjoy reading about your work, Soni. I've been thru this thread more than once now. Please keep sending updates! Thanks ciao lino

Here are some pics of my rear winch setup. Integrated with height adjustable receiver mount.

When the valve is powered off, and the solenoid open and venting to atmosphere, what is the regulator doing? Wouldn't it be driving (or trying to) 3 psi to atmosphere? Or do you dial "off" the regulator when not in use? So to turn on, you flip solenoid switch, and dial regulator from zero to...