Recent content by lordkevork

LOL We bid them up there didn't we? What do you think they are worth? Some ppl think i'm nuts for paying that much for them and some think it was a good deal. i'm happy with them though, They actually run mint and were loaded with plenty of good tools too. Going to use one as a plow truck and...

yes i have two of these trucks. I have truck keys but not the key for utility body locks. i tried the search and came up empty unless i'm searching with wrong search term

I have been searching everywhere for a key code for the SECM body. Anyone know what it is? If i can get a key cut it would save me the time of taking a lock out and taking it to the locksmith. The trucks are 84,86 chevy DRW M1028A3's with the old utility bodies with welder,compressor, genset...

nopics

Pulling the speedo cable does make it easier but you can squeeze in there to change them without pulling cable if you have small hands. I have large (what my kids call Murderer hands & Sausage fingers) and i swapped my lamps out. I did have to pull the cable to replace the low airpressure sender...

That is awesome! Good luck with it

Me niether. All 4 trucks went out of control as if they were painted with gold.

New "Dirty" Jersey

My A3 has 5000 miles on it and i paid half of what this A2 cost me. The A2 really looked flawless in person though and sounded mint. I'll have fun with it for a few weeks and I already have it sold for twice what i paid.

I bought one of those. Only got it cause i had a buddy check em out and can't get over how clean and new they look. Tried getting all four but prices were getting way out of hand.

Installed drivers side mirrors to replace the one that rotted off, rebuilt air dryer, adjusted steering air regulator, repaired washer fluid pump, replaced ether can. Getting ready to replace all the seals and o-rings in the wheels and hubs, bearings, lube & new tires next week (395's). Having...