• Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!

  • Microsoft MSN, Live, Hotmail, Outlook email users may not be receiving emails. We are working to resolve this issue. Please add support@steelsoldiers.com to your trusted contacts.

LuckeyD's latest activity

  • L
    LuckeyD replied to the thread MEP-804B putting out only 50HZ.
    We found a no answer means 1 of 2 things. 1- All is good. Found the issue or is using the test wire. 2. he is busy with daily life...
  • L
    LuckeyD replied to the thread DRASH Unit AC issue.
    Cool! THIS IS NOT A DRASH. This is a PSI system and the issued 6 different models, and it was a combined effort done for the defunct...
  • L
    LuckeyD replied to the thread DRASH Unit AC issue.
    Good Day. I'm Dave. This is gonna sound funny, any way to find out what model your working with? I'll bet I have the info your...
  • L
    LuckeyD replied to the thread 803A Hits a Wall at 9.3kW.
    OK, you got 9000 watts. Run it with that or about 8500 Watts and after a while it may even provide more as the rings seat again and...
  • L
    LuckeyD replied to the thread Mep-802a temp gauge reading..
    Seems two folks using the same stuff with same results kinda sorta resolves the issue. Nominal readings in the desert at 115F outside...
  • L
    LuckeyD replied to the thread Mep 803a No/Low Low Power Output.
    That TB 10 is located inside the main gen and you have to remove the main gen back panel with 6 bolts if I remember right. Only had 2...
  • L
    LuckeyD replied to the thread 803A Hits a Wall at 9.3kW.
    An extra gage you can verify your panel gage. The panel gage may be incorrect. The LOP is set for just under 20PSI. Hope so ruling...
  • L
    LuckeyD replied to the thread Need Help with my 802A …..
    We used 802A gen with the raid system in the war zones. They were connected to 2, 55 gallon drums and ran on AUX fuel 24/7, 365 and...
  • L
    LuckeyD replied to the thread New to me MEP-803a.
    Unburnt fuel residue. Higher loads may burn this tar looking stuff off with time as it cleans itself out on your loads. You may even...
  • L
    Get her home; start at one end and work to the other. Slap a set of batteries in it (nice if they were old recharged). Now look...
  • L
    LuckeyD replied to the thread 803A Hits a Wall at 9.3kW.
    Good Day. Your initial issue is your gen shuts down after a while on a load that is gradually increased with messing with it. The key...
  • L
    LuckeyD replied to the thread New to me MEP-803a.
    In words of my mentor; "GOOD DEAL". I use the same amp probe. You indicate 50 AMPS set at 120/240VAC out. The attached is a pic out...
  • L
    LuckeyD replied to the thread Fuel drain for MEP 803A.
    See OEM parts below. Page 2 line 50 left side. The comments so far have provided a metal tank drain plug. That puppy should work...
  • L
    LuckeyD replied to the thread MEP 802 belly panel.
    The side vents and that big hole is for cooling according to the manufacturer. Best listen to the comment from GUY. Those smaller...
  • L
    LuckeyD replied to the thread MEP-802A questions.
    Codes are from the unit level maintenance computer and mean how fast they are supposed to be addressed. NCOMP is a program where a...
Top