-
Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!
LuckeyD's latest activity
-
LLuckeyD replied to the thread MEP-1050 Fault Code 3665.They tried to show in the manual the part of the S12 that was sticking out . I was explained to that the ON is a BIT 1 in digital...
-
LLuckeyD replied to the thread MEP-1050 Fault Code 3665.Good Day: Manuals, please down load them, and then use them, both operators and maintenance versions. These in the forum you are...
-
LLuckeyD replied to the thread MEP-804A Voltage issues..Good day: Please do not start the gen anymore until you check out the regulator TR1 and AC Voltage adjust combinations. I attached a...
-
LLuckeyD replied to the thread S-250 AN/TSM-183 New Project.This was as i was retiring and becoming an ECU and Gen answer man. Hid away I found TM 11-4940-483-13&P dated 1 March 1989 with Change...
-
LLuckeyD replied to the thread Mep 803a No/Low Low Power Output.I am very glad you found your issue with AC output. I attached several PDF docs. I always use the DMM to set things as the gages are...
-
LLuckeyD replied to the thread MEP-804B putting out only 50HZ.Flop open the control panel by the half turn thumb screws on the top of the control panel. If the rope is busted fix it with any rope...
-
LLuckeyD replied to the thread MEP-804B putting out only 50HZ.We found a no answer means 1 of 2 things. 1- All is good. Found the issue or is using the test wire. 2. he is busy with daily life...
-
LLuckeyD replied to the thread DRASH Unit AC issue.Cool! THIS IS NOT A DRASH. This is a PSI system and the issued 6 different models, and it was a combined effort done for the defunct...
-
LLuckeyD replied to the thread DRASH Unit AC issue.Good Day. I'm Dave. This is gonna sound funny, any way to find out what model your working with? I'll bet I have the info your...
-
LLuckeyD replied to the thread 803A Hits a Wall at 9.3kW.OK, you got 9000 watts. Run it with that or about 8500 Watts and after a while it may even provide more as the rings seat again and...
-
LLuckeyD replied to the thread Mep-802a temp gauge reading..Seems two folks using the same stuff with same results kinda sorta resolves the issue. Nominal readings in the desert at 115F outside...
-
LLuckeyD replied to the thread Mep 803a No/Low Low Power Output.That TB 10 is located inside the main gen and you have to remove the main gen back panel with 6 bolts if I remember right. Only had 2...
-
LLuckeyD replied to the thread 803A Hits a Wall at 9.3kW.An extra gage you can verify your panel gage. The panel gage may be incorrect. The LOP is set for just under 20PSI. Hope so ruling...
-
LLuckeyD replied to the thread Need Help with my 802A …..We used 802A gen with the raid system in the war zones. They were connected to 2, 55 gallon drums and ran on AUX fuel 24/7, 365 and...
-
LLuckeyD replied to the thread New to me MEP-803a.Unburnt fuel residue. Higher loads may burn this tar looking stuff off with time as it cleans itself out on your loads. You may even...