Recent content by lurch44

Dav5 The well nut is the same for the top sending unit and the bottom fuel drain. I had just gotten replacing mine. I bought 2 from GMG. Just remember 40 inch pounds.I just wiped out the inside of the hole.

Diesel Addict I was referring to the Delvac 1300 diesel 15W40 oil that I use in my 6.2 and other diesel toys. I use Mobil 1 synthetic in my gassers.

I use the Mobil Delvac 1300 in my diesel toys and my gassers get Mobil 1 syn stuff. I was just wondering if Delvac by Mobil was acceptable or since the engine seems to run at one speed there would be a better oil for a seemingly constant rpm engine.

Great story Guyfang I was all excited because I had built a loadbank out of a 35 gallon empty lithium bromide container and 3 water heater elements and I had run this at approx 11,000 for a good run and was all happy I didnt have chunks of carbon blowing out. The smoke cleared up at 15 to 30...

Ok I will stay with my value engineered solution. Thanks to everyone who steered me in the right direction. I swear I looked the whole thing over the first day for almost 2 hours and never saw a friggin drip. Just saw glycol everywhere from the fan drawing thru. this is why I got nervous Nelly.

Ok I will stay with my value engineered solution. Thanks to everyone who steered me in the right direction. I swear I looked the whole thing over the first day for almost 2 hours and never saw a friggin drip. Just saw glycol everywhere from the fan drawing thru. this is why I got nervous Nelly.

Too funny Kloppk That is exactly what I had done with a piece of steel rod. In my younger days I would have used a 1/2" bolt.

Thanks for the reply I will check tomorrow after work. I have it rigged(value engineered) for now. Next time I flush coolant system I will RR part with new one. I noticed the glycol seemed very thick like it was straight ethylene glycol and not a mix of water and antifreeze. I added about a...

Thanks Kloppk After letting it sit for a day sure enough and wiping everything spotless. There was a big drool puddle from the cap on the unused port of the water pump. This time I actually watched a couple of drips. I never saw a drip yesterday. This is why I got nervous with the fan flinging...

Thanks kloppk. I was suspecting the rubber cap but the amount of coolant in the bottom had me suspecting something bigger. Like I had mentioned I had looked for a couple of hours but saw no evidence of any fittings drooling. I will check tomorrow after work and report back. I would have started...

Good evening Long time lurker here. I finally scored a MEP-803A on Sat. I spent the next 2 days going over everything I have learned on here for the last year. I built a load bank so I could put it through its paces. I ran it for about 3 hours straight loading slowly then running it to...

Looking for info on my M1028A1 Dear Carnac I have recently acquired a M1028A1 and was looking for info please a)1GCHD34J7FF350596 b) c)2320011580820 d)private seller in Swoope Va who said he got in from Warsaw NC? e)FWD588(left side) MI33(right side) there was also an old number under that and...

TEST TEST TEST Dear Carnac blah blah blah