Recent content by matiasmaggiolo

Hi, i have problems with my hydroboster for my cucv m1009. I had order 1 from EBAY but this repair hydrobooster come bad too. As now i have 2 hydrooboster in bad conditions i need buy hydroobooster kit repair to repair here in Argentina. Do you know where i can buy 2 sets?? thank you.

Another point, pls could tell me what is better, make this rewire and work GP at 12volts and all the rest to 12v and started to 24volts, OR buy GP OF 24 VOLTS AND BY PASS THE RESISTOR AND USE THE ALL THE GP AND STARTER IN 24V. ???

Crash, thank you , pls see the attach becose i am not sure. The Original Wire is the wire that goes from the Resistor to the GP RELAY. For the New Rewire i need Pull the wire from the Resisto and put in the POSITIVE of the 12V JUNCTION BLOCK . PLS SEE THE LINES AND TELL IF I UNDERSTAND ALL OK...

Hi, My M1009 86 had burned all my NEW WELLMANN 070 AGAIN, so my mechanic wants convert to 12v just the GLOW PLUG SYSTEM, and maintein the rest original 24v system. He said that this is easy becose he takes 12v from 1 of the battery and send to a 12v Glow Plug controler , just that. So if in...

Ok so i will try to put the blue cable on negative gp relay to see if it can resolv the problem. I will advice you,or you consider another point ??

is thi possible ?? that with out apply that cable , the GP works fine. I just have the WAIT LIGTH problem since i put the new 2 batterys. What do you think ??? is complety normal that in cold machine status the wait ligth appear for 8 sec then desappear for 1 minute aprox. and then appear...

But where is the glow plug relay ¿?, are you sure pls note that this wire always was not applied. Pls could you tell me where is the glow plug relay ?

Dearrs, i need help, my m1009 works perfec and this is REALLY NEW . My wait light always worked perfect. ( when the machine was cold the light on during 8 sec. aprox, and then NEVER APPEAR AGAIN ). and when the machine was warm the ligth just appear and disapear asap. 3 days ago i put 2 new...

hi this is Matias from argentina, i have a 86 M1009, and the machine always had good start but since 1 week it not start any more, i had see that all the Glow PLug are BAD, and here the unique glow plug i can buy is BERU 0100271101. this glow up it take 8 sec. Do you think that it will work.