-
Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!
Recent content by Mfoley
-
M
Need assistance have a M1097 A2 in Limp mode
Ok found the pic for the trans connector… will move the pins. -
M
Need assistance have a M1097 A2 in Limp mode
Here’s a pic of the trans connection. Matches the diagram from TM on page 141. However the plug has to be flipped so the arrow on the plug is on top for it to plug in….also every row is backwards right to left…... -
M
Need assistance have a M1097 A2 in Limp mode
Well still not shifting but got codes 59, 81, 82, and 83. -
M
Need assistance have a M1097 A2 in Limp mode
Ok repinned the whole plug to match the diagram. Turned on power no light. Changed out the computer Light is working! Didn’t get a chance to drive but will try it out on Monday. Thanks for your help! -
M
Need assistance have a M1097 A2 in Limp mode
Definitely missed wired. 290D is plugged to L and 923 is in E. I’ll get that repinned and see if it will shift! Thanks for your assistance -
M
Need assistance have a M1097 A2 in Limp mode
Ok. Did a lot checking today. I went over the entire wiring harness and there is no damage /kinks or nicks. Everything is plugged in with good connections. So I went back to the TM (pg 141). and looked for power First on TCM plug J1. I found ingition power on j . I was looking at J before... -
M
Need assistance have a M1097 A2 in Limp mode
Yes, sorry. No continuity from trans relay to TCM plug or to the trans connetion. I will check from TCM plug to transmission connection and see if they have continuity. Thanks again for your help -
M
Need assistance have a M1097 A2 in Limp mode
Mogman I have looked over the wiring harness and cannot find any points that look damage. the wiring diagram on pg 114 of the manual shows the 12v power on 291c coming together at some point. Since I have power at the bake switch and the trans light but not at the trans and TCM where should... -
M
Need assistance have a M1097 A2 in Limp mode
290B/291B Go to 4. 290C/291C. Go to 3 -
M
Need assistance have a M1097 A2 in Limp mode
finally got a chance to work on this. Grounding the TCM at U turns on the mil light. I have 12v battery at Z but nothing on J with ignition on. Ground on a & b are good. Im assuming my next step is figuring why I don’t have ignition 12v on J but I do have it coming out of the trans relay... -
M
Need assistance have a M1097 A2 in Limp mode
Hi Mogman, Thanks for the help! I will post my results as soon as I get a chance to do this. -
M
Need assistance have a M1097 A2 in Limp mode
Purchased this one knowing it was not running and had been pretty well cannibalized. I have gotten it back together and it is now running and moving well just 2nd gear. I realized I am not getting ignition power to the trans or the TCM. I replaced the transmission relay and now have power...