Recent content by mgreene

IN

“IN”

IN

I have changed many on tractors but not these. I saw to line up the hole in the bell housing with the plug on the same side as the IP and then check the marks inside the small foot on the IP? If I do the same with both engines I hope it will be pretty close? Only question is what still of puller...

Just a little update! After soaking my injection pump in a bath of marvel mystery oil it still doesn’t seem to move quiet as free as I think it should. A neighboring FD just happened to have a 805-A identical to ours. They messed up the generating side about a year ago so insurance bought them a...

I went today and installed the missing fuse! Upon startup the voltage gauge immediately went up Obote 100 volts! I hooked the meter to 2 of the line output terminals and my first few try’s at closing the contractor didn’t work. I would get voltage output as I held the toggle switch in the closed...

It’s fine Guyfang,,,,I can deal with some nagging ( I have lived with my wife for over 20 years��). I haven’t spent as much time in the manuals or on the forum as I should have due to working 50 plus hours a week and then trying to figure this thing out in my down time for our...

I have been reading the books but when one person post things to check from the TM and then the next assumes I should know every word front to back in the operation manual,, guess I’m just not quick enough? As I posted I followed the directions exactly in settings the 2 1/2 volts that I am...

Would I be better off to start a new post to get responses about the electrical side? I know it is moving off topic from my original post??

Thanks man,,,,enjoyed it so far! If everyone can help me get this generator straightened out that we got at the fire department before the next storm blows through! Florence is almost as close to me as Lumberton is! Hopefully we are working towards picking up a deuce and a quarter or half to...

I know this is a very old post but it’s good to find “local” guys using this forum! Seems great so far!!

So here is what I have learned today. The top of the IP does have a fair amount of rust. After soaking last night in penetrating oil, everything moves a little more free than it did but it still needs more soaking/ working! I re installed the MPU per TM direction and then disconnected the two...

I was able to pull up each manual Regis morning before my kids got up and overloaded my internet speed! I will re check ohms in the control panel this afternoon as well as voltage and see where I get from that. Any additional tips on freeing up the governor or shutdown parts in the top of the...

I did remove it after to check and everything looked clean. I saw someone had posted the ohm reading should be I think between 900-1200. Mine being only slightly over 1 I was already sourcing a new sensor? I have been reading through the 300 page books but by the time my internet gets one...

So here is my update after about 4 more hours of aggravation this afternoon! I started with the MPU. Upon touching the wires one of them fell out of the connector so I quickly repaired that thinking I had found my issue. No difference! I checked the ohms and only get around 1.3 ohms between the...